Advertisement

The Assembly Redesign of Cage Rotor Separator

  • Li Kunshan
  • Li YangEmail author
Conference paper
Part of the Advances in Intelligent Systems and Computing book series (AISC, volume 691)

Abstract

The method of using three-dimensional design of the main components cage rotor separator were optimized, according to the green design theory, to meet the minimum number of parts of the design method and the direction of the minimum assembly direction; according to the part interlock feature, to achieve the main assembly process in the equipment outside the design method and structure of the principle of symmetrical design. The numerical simulation method is used to simulate the flow field of the separator, especially the influencing factors of the flow field of the rotor system. The optimal performance of the redesign is verified by the experimental data.

Keywords

Separator Assembly Design Numerical simulation Green environmental friendly 

References

  1. 1.
    Kunshan, L.: The design and development of the non-ball mill. Miner. Mt. Mach. 7, 24–27 (2002)Google Scholar
  2. 2.
    Kunshan, L.: The characteristic and theory of LKS non-ball mill. Symp. Refract. 5, 316 (2002)Google Scholar
  3. 3.
    Kunshan, L., Mo, Y.: The design and development of non-ballGoogle Scholar
  4. 4.
    Boger, Z.: Application of neural networks to water and wastewater treatment plant operation. ISA Trans. 31(1), 25–33 (1992)CrossRefGoogle Scholar
  5. 5.
    Kunshan, L.: Rare earth superfine powers fabrication and characterization by novel non-ball miller. Mechatron. Mater. Process. 11, 648–653 (2011)Google Scholar
  6. 6.
    Kunshan, L.: Simulation of failure detection based on neural network for no-ball mill. Adv. Manuf. Syst. 4, 627–631 (2011)Google Scholar
  7. 7.
    Kunshan, L.: The re-design of centrifugal classifier. Adv. Metall. Min. Eng. 12, 820–823 (2011)Google Scholar
  8. 8.
    Kunshan, L.: Classifers’ environmental friendly(green)re-design. Autom. Equip. Syst. 3, 658–662 (2012)Google Scholar
  9. 9.
    Kunshan, L.: The use of solid edge in the classifiers design. Adv. Manuf. Technol. 3, 2080–2083 (2012)Google Scholar
  10. 10.
    Kunshan, L.: The assembly design of non-ball mills. Adv. Des. Res. Manuf. 8, 65–68 (2013)Google Scholar
  11. 11.
    Kunshan, L.: Design of non-ball mill based on the green conception. Adv. Des. Res. Manuf. 8, 73–76 (2013)Google Scholar
  12. 12.
    Leschinski, K.: Classification of particles in the submicron range in an impeller wheel air classifier. KONA Powder Part. 14, 52–60 (1996)CrossRefGoogle Scholar

Copyright information

© Springer International Publishing AG 2018

Authors and Affiliations

  1. 1.School of Mechanical EngineeringUniversity of JinanJinanPeople’s Republic of China

Personalised recommendations