Advertisement

Electron Beam and Photoemission Probing

  • Selahattin Sayil
Chapter

Abstract

Electron beam testing (EBT) is the most widely used contactless probing technique for internal timing characterization and for diagnostic of digital integrated circuits. This technique uses an electron beam to stimulate secondary electron emission from metallized surfaces. It uses the energy distribution function of the released secondary electrons which is in turn a function of the voltage at the test point. A very attractive feature of EBT is the quick and easy positioning of the electron beam probe and the possibility of making micrographs at any desired location in short time. It is the most industrially developed contactless testing technique. The photoemissive probe, on the other hand, uses a pulsed optical beam of a certain energy to probe a signal on a metal line of any substrate. The optical beam causes photoelectrons to be emitted from the top layer of a metal from which the waveform of the signal is derived.

Keywords

Electron beam testing Scanning electron microscope Photoemissive probe Contactless probe 

References

  1. 1.
    W.T. Lee, Engineering a device for electron beam probing. IEEE Des. Test Comput. 6, 36–49 (1989)CrossRefGoogle Scholar
  2. 2.
    M. Sartori, Contactless testing using EB techniques: an important support to the debug of modern VLSI, in 1995 International Semiconductor Conference (CAS), Sinaia, October 1995Google Scholar
  3. 3.
    P.E. Garrou, I. Turlik, Multichip Module Technology Handbook (McGraw Hill, New York, 1998)Google Scholar
  4. 4.
    T.C. May, G.L. Scott, E.S. Meieran, P. Winer, V.R. Rao, Dynamic fault imaging of VLSI random logic devices, in Proceedings of International Reliability Physics Symposium, Las Vegas, 1984Google Scholar
  5. 5.
    D. Winkler, R. Schmitt, Flexible picosecond probing of IC’s with chopped e-beams. IBM J. Res. Dev. 34(2/3), 189–202 (1990)CrossRefGoogle Scholar
  6. 6.
    J. Fehr, E. Kubalek, Electron beam test system for GHZ-waveform measurement on transmission lines within MMIC, in Proceedings of 22nd European Microwave Conference, Helsinki, vol. 1, 1992, pp. 22–25Google Scholar
  7. 7.
    F. Marc, H. Fremont, P. Jounet, M. Barre, Y. Danto, A general methodology using an electron beam tester applied to failure localization inside a logic IC. Microelectron. Eng. 26, 181–193 (1995)CrossRefGoogle Scholar
  8. 8.
    G. Solkner, C. Wolfgang, Advanced diagnosis techniques for sub-μm IC’s. Microelectron. Eng. 22, 11–16 (1994)Google Scholar
  9. 9.
    H.K. Seitz, A. Blacha, R. Clauberg, H. Beha, Energy and time-resolved photoemission in a promising new approach for contactless IC testing. Microelectron. Eng. 5, 547–553 (1986)CrossRefGoogle Scholar
  10. 10.
    R. B. Marcus, Measurement of High-Speed Signals in Solid State Devices. Semiconductors and Semimetals, vol. 28 (Academic, Boston, 1990)Google Scholar
  11. 11.
    A.M. Weiner, Picosecond temporal resolution photoemissive sampling. Appl. Phys. Lett. 51, 358–360 (1987)CrossRefGoogle Scholar

Copyright information

© Springer International Publishing AG 2018

Authors and Affiliations

  • Selahattin Sayil
    • 1
  1. 1.Lamar UniversityBeaumontUSA

Personalised recommendations