Abstract
The motivation of the present work is first to conduct the validation of a Computational Fluid Dynamics (CFD) code, for different methane-hydrogen fuel blends in a spark-ignition (SI) engine, focusing on the newly developed combustion model. This validation is based on both performance and emissions comparison with experimental data, in order to gain a complete view of the code capabilities. Then, a detailed combustion analysis is conducted, by further processing the results of the numerical code, providing insight of the flame front propagation and emissions production inside the engine cylinder. The available experimental data are from a two-cylinder SI engine with complete sets of measured values. For the current study it has been decided to focus on the effect of variable hydrogen content (from 0 up to 50 % by vol. hydrogen). The CFD code is an in-house code and has been initially developed for simulating hydrogen-fueled SI engines. Lately, its combustion model has been extended with the introduction of methane fuel and the reaction rates are calculated with the characteristic conversion time-scale method, while the flame front is tracked using a laminar and turbulent combustion velocity. The nitric oxide (NO) emissions are calculated according to the widely-used Zeldovich mechanism. The CFD code validation includes the comparison of calculated performance values (pressure history and heat release rates) with the measured ones for variable hydrogen content. The calculated NO emissions are also compared with the measured ones for the same conditions. From this comparison it has been revealed that a good match exists for both performance and emissions, showing that the code can be applied for detailed investigation of such combustion processes. Finally, a detailed combustion analysis is implemented with the support of the measured data, in order to examine the combustion processes and flame propagation for the different fuel blends.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Similar content being viewed by others
References
Abraham, J., Bracco, F. V., & Reitz, R. D. (1985). Comparison of computed and measured premixed charge engine combustion. Combustion and Flame, 60(3), 309–322.
Agathou M. S., & Kyritsis, D. C. (2014). Experimental study of steady, quasi cone-jet electrostatic sprays of bio-butanol for engine applications. Journal of Energy Engineering 140(3). doi: 10.1061/(ASCE)EY.1943-7897.0000141, A4014008.
Akansu, S. O., Kahraman, N., & Ceper, B. (2007). Experimental study on a spark ignition engine fuelled by methane-hydrogen mixtures. International Journal of Hydrogen Energy, 32(17), 4279–4284.
Aliramezani, M., Chitsaz, I., & Mozafari, A. A. (2013). Thermodynamic modeling of partially stratified charge engine characteristics for hydrogen-methane blends at ultra-lean conditions. International Journal of Hydrogen Energy, 38(25), 10640–10647.
Demuynck, J., Raes, N., Zuliani, M., De Paepe, M., Sierens, R., & Verhelst, S. (2009). Local heat flux measurements in a hydrogen and methane spark ignition engine with a thermopile sensor. International Journal of Hydrogen Energy, 34(24), 9857–9868.
Dimopoulos, P., Rechsteiner, C., Soltic, P., Laemmle, C., & Boulouchos, K. (2007). Increase of passenger car engine efficiency with low engine-out emissions using hydrogen–natural gas mixtures: A thermodynamic analysis. International Journal of Hydrogen Energy, 32(14), 3073–3083.
Gerke, U., Steurs, K., Rebecchi, P., & Boulouchos, K. (2010). Derivation of burning velocities of premixed hydrogen/air flames at engine-relevant conditions using a single-cylinder compression machine with optical access. International Journal of Hydrogen Energy, 35(6), 2566–2577.
Kosmadakis, G. M., Pariotis, E. G., & Rakopoulos, C. D. (2013). Heat transfer and crevice flow in a hydrogen-fueled spark-ignition engine: Effect on the engine performance and NO exhaust emissions. International Journal of Hydrogen Energy, 38(18), 7477–7489.
Kosmadakis, G. M., & Rakopoulos, C. D. (2014a). Computational fluid dynamics investigation of alternative nitric oxide emission mechanisms in a hydrogen-fueled spark-ignition engine. International Journal of Hydrogen Energy, 39(22), 11774–11791.
Kosmadakis, G. M., & Rakopoulos, C. D. (2014b). Computational fluid dynamics study of alternative nitric-oxide emission mechanisms in a spark-ignition engine fueled with hydrogen and operating in a wide range of exhaust gas recirculation rates for load control. Journal of Energy Engineering C4014008. DOI: 10.1061/(ASCE)EY.1943-7897.0000229.
Kosmadakis, G. M., Rakopoulos, C. D., Demuynck, J., De Paepe, M., & Verhelst, S. (2012). CFD modeling and experimental study of combustion and nitric oxide emissions in hydrogen-fueled spark-ignition engine operating in a very wide range of EGR rates. International Journal of Hydrogen Energy, 37(14), 10917–10934.
Lipatnikov, A. N., & Chomiak, J. (1997). A simple model of unsteady turbulent flame propagation. Transactions SAE Journal of Engines 106:2441–2452 [SAE Paper no. 972993].
Ma, F., Liu, H., Wang, Y., Li, Y., Wang, J., & Zhao, S. (2008). Combustion and emission characteristics of a port-injection HCNG engine under various ignition timings. International Journal of Hydrogen Energy, 33(2), 816–822.
Moreno, F., Muñoz, M., Arroyo, J., Magén, O., Monné, C., & Suelves, I. (2012). Efficiency and emissions in a vehicle spark ignition engine fueled with hydrogen and methane blends. International Journal of Hydrogen Energy, 37(15), 11495–11503.
Ouimette, P., & Seers, P. (2009). Numerical comparison of premixed laminar flame velocity of methane and wood syngas. Fuel, 88(3), 528–533.
Papagiannakis, R. G., & Zannis, T. C. (2013). Thermodynamic analysis of combustion and pollutants formation in a wood-gas spark-ignited heavy-duty engine. International Journal of Hydrogen Energy, 38(28), 12446–12464.
Rakopoulos, D. C. (2012). Heat release analysis of combustion in heavy-duty turbocharged diesel engine operating on blends of diesel fuel with cottonseed or sunflower oils and their bio-diesel. Fuel, 96, 524–534.
Rakopoulos, D. C. (2013). Combustion and emissions of cottonseed oil and its bio-diesel in blends with either n- butanol or diethyl ether in HSDI diesel engine. Fuel, 105, 603–613.
Rakopoulos, C. D., & Giakoumis, E. G. (2009). Diesel engine transient operation—principles of operation and simulation analysis. London: Springer.
Rakopoulos, C. D., Kosmadakis, G. M., Demuynck, J., De Paepe, M., & Verhelst, S. (2011). A combined experimental and numerical study of thermal processes, performance and nitric oxide emissions in a hydrogen-fueled spark-ignition engine. International Journal of Hydrogen Energy, 36(8), 5163–5180.
Rakopoulos, C. D., Kosmadakis, G. M., & Pariotis, E. G. (2010a). Evaluation of a combustion model for the simulation of hydrogen spark-ignition engines using a CFD code. International Journal of Hydrogen Energy, 35(22), 12545–12560.
Rakopoulos, C. D., Kosmadakis, G. M., & Pariotis, E. G. (2010b). Critical evaluation of current heat transfer models used in CFD in-cylinder engine simulations and establishment of a comprehensive wall-function formulation. Applied Energy, 87(5), 1612–1630.
Rakopoulos, C. D., & Kyritsis, D. C. (2006). Hydrogen enrichment effects on the second law analysis of natural and landfill gas combustion in engine cylinders. International Journal of Hydrogen Energy, 31(10), 1384–1393.
Rakopoulos, C. D., & Michos, C. N. (2009). Generation of combustion irreversibilities in a spark ignition engine under biogas-hydrogen mixtures fueling. International Journal of Hydrogen Energy, 34(10), 4422–4437.
Wang, S., Ji, C., & Zhang, B. (2010). Effect of hydrogen addition on combustion and emissions performance of a spark-ignited ethanol engine at idle and stoichiometric conditions. International Journal of Hydrogen Energy, 35(17), 9205–9213.
Zimont, V. L. (2000). Gas premixed combustion at high turbulence. Turbulent flame closure combustion model. Experimental Thermal and Fluid Science, 21(1–3), 179–186.
Acknowledgement
Dr. G.M. Kosmadakis (NTUA) wishes to thank the Greek State Scholarships Foundation for granting him an “IKY Fellowship of excellence for postgraduate studies in Greece—Siemens Program, years 2013–2015.”
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2016 Springer International Publishing Switzerland
About this chapter
Cite this chapter
Kosmadakis, G.M., Moreno, F., Arroyo, J., Muñoz, M., Rakopoulos, C.D. (2016). Spark-Ignition Engine Fueled with Methane-Hydrogen Blends. In: Grammelis, P. (eds) Energy, Transportation and Global Warming. Green Energy and Technology. Springer, Cham. https://doi.org/10.1007/978-3-319-30127-3_31
Download citation
DOI: https://doi.org/10.1007/978-3-319-30127-3_31
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-30126-6
Online ISBN: 978-3-319-30127-3
eBook Packages: EnergyEnergy (R0)