Abstract
The annual performance of a parabolic trough collector (PTC) concentrating solar power (CSP) system without storage or backup is predicted for Antalya (Turkey) and Güzelyurt and Larnaca on the island of Cyprus by modeling the system with TRNSYS software. The model is established to be similar to the 30 MWe CSP plant (SEGS VI) in Kramer Junction, California. The model is benchmarked with published results for Kramer Junction and Antalya, and good agreement is found. Based on irradiation maps, Güzelyurt is expected to be one of the sunniest areas on Cyprus, but hourly meteorological data are not supplied with TRNSYS for this location. Meteorological data in TMY2 format are available in TRNSYS for Larnaca. In this work, TMY2 data for Güzelyurt is created using Meteonorm software. The investigation of the performance of a CSP plant for these two locations on the island of Cyprus is one of the main objectives of this paper. The annual performance of these systems is predicted by performing simulations using an hourly time step. Results for typical clear and cloudy days are compared for the three locations. The highest monthly average net power outputs are observed for Güzelyurt. Finally, the capacity factor of the CSP plant is investigated for different solar multiples for a solar-only PTC plant without hybridization or thermal storage for all three locations. Results show that maximum power outputs are obtained for Güzelyurt. For our solar-only system, solar multiples of 1.1–1.3 have good results, but for solar multiples greater than 1.3, an excess amount of solar resources starts to be wasted, so that storage is recommended especially for Güzelyurt.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Abbreviations
- Q solarinput :
-
Net heat input at the collector
- m HTF :
-
Mass flow rate of heat transfer fluid
- C p,HTF :
-
Constant pressure specific heat of heat transfer fluid
- T output :
-
Outlet temperature of collector
- T input :
-
Inlet temperature of collector
- SMdesignpoint :
-
Solar multiple at design point
- CF:
-
Capacity factor
- θ :
-
Angle of incidence
- K :
-
Constant relating solar multiple to collector field area
- e:
-
Electricity
References
Lippke F (1995) Simulation of the part load behavior of a 30 MWe SEGS Plant. Prepared for Sandia National Laboratories, Albuquerque, NM, SAND95-1293
Wahl P (1992) Object-oriented design and implementation of a software system for calculating the part-load conditions of solar electric power plants (in German). ZSW report, SOT-WS 12/92
Jones SA, Pitz-Paal R, Schwarzboezl P, Blair N, Cable R (2001) TRNSYS modeling of the SEGS VI parabolic trough solar electric generating system. Proceedings of solar forum, Washington, DC, USA
University of Wisconsin-Madison. Solar Energy Laboratory, Klein SA (1979) TRNSYS, a transient system simulation program. Solar Energy Laboratory, University of Wisconsin-Madison
Pitz-Paal R, Jones SA (1998) A TRNSYS model library for solar thermal electric components (STEC), a reference manual, Release 1.0. IEA-Solar Power and Chemical Energy Systems, Task III: Solar Technologies and Applications
Stuetzle T, Blair N, Mitchell JW, Beckman WA (2004) Automatic control of a 30 MWe SEGS VI parabolic trough plant. Sol Energy 76:187–193
Patnode MA (2006) Simulation and performance evaluation of parabolic trough solar power plants. Thesis, University of Wisconsin, Madison, USA
Klein SA, Alvardo FL (2002) Engineering equation solver. F-Chart Software. Madison, WI
Usta Y, Baker D, Kaftanoğlu B (2011) Modeling and simulations of a 30 Mwe solar electric generating system using parabolic trough collectors in Turkey. Proceedings of international green energy conference VI (IGEC VI), Eskisehir, Turkey
Usta Y (2010) Simulations of a large scale solar thermal power plant in Turkey using concentrating parabolic trough collectors. Thesis, Middle East Technical University, Turkey
Montes MJ, Abánades A, Martinez-Val JM, Valdés M (2009) Solar multiple optimization for a solar-only thermal power plant, using oil as heat transfer fluid in the parabolic trough collectors. Sol Energy 83:2165–2176
Remund J, Kunz S (1997) METEONORM: global meteorological database for solar energy and applied climatology. Meteotest
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2015 Springer International Publishing Switzerland
About this chapter
Cite this chapter
Bilyaz, S., Singh, R., Karshenass, A., Baker, D. (2015). Modeling and Transient Simulations of 30 MW Solar Thermal Electric Power Plants in the Northeast Mediterranean Region. In: Dincer, I., Colpan, C., Kizilkan, O., Ezan, M. (eds) Progress in Clean Energy, Volume 2. Springer, Cham. https://doi.org/10.1007/978-3-319-17031-2_73
Download citation
DOI: https://doi.org/10.1007/978-3-319-17031-2_73
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-17030-5
Online ISBN: 978-3-319-17031-2
eBook Packages: EnergyEnergy (R0)