Abstract
Dental resin composites are widely applied in dental restoration. These resin composites have some problems due to shrinkage occurred. Since shrinkage stress could be presented by resin matrix polymerization as tensile stress and causes structure failure. In this study, four types of dental composites (Z350 flow, universal composite Z250, packable composite P60, and low-shrinkage composite LS) were chosen to investigate their tensile creep and recovery behavior. The specimens were divided into two groups: (1) after curing about 5 min, and (2) stored in artificial saliva for 30 days. With force control, the specimen image under uni-axial tension was recorded and analyzed by using digital image correlation (DIC) method. Four-parameter fluid model is found applicable to fit the experimental obtained strain. The results showed that the longitudinal strain of 5-min case has higher creep and residual strain than that of 30 days. The creep of LS was the smallest in four resin composites. The Poisson’s ratio of 5-min case was increased about 0.5 with time except for LS. However, the Poisson’s ratio of 30-day cases varied up and down insignificantly with time.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Sun R, Suansuwan N, Kilpatrick N, Swain M (2000) Characterisation of tribochemically assisted bonding of composite resin to porcelain and metal. Am J Dent 28(6):441–445
Vano M, Goracci C, Monticelli F, Tognini F, Gabriele M, Tay FR, Ferrari M (2006) The adhesion between fibre posts and composite resin cores: the evaluation of microtensile bond strength following various surface chemical treatments to posts. Int Endod J 39(1):31–39
Beun S, Bailly C (2012) Physical, mechanical and rheological characterization of resin-based pit and fissure sealants compared to flowable resin composites. Dent Mater 28:349–359
Braga RR, Ferracane JL (2004) Alternatives in polymerization contraction stress management. Crit Rev Oral Biol Med 15:176–184
Tantbirojn D, Pfeifer CS, Braga RR, Versluis A (2011) Do low-shrink composites reduce polymerization shrinkage effects? J Dent Res 90(5):596–601
Baroudi K, Silikas N, Watts DC (2007) Time-dependent visco-elastic creep and recovery of flowable composites. Eur J Oral Sci 115:517–521
Bhamra GS, Fleming GJP (2012) Influence of halogen irradiance on short- and long-term wear resistance of resin-based composite materials. Dent Mater 25(2):214–220
Schmidt C, Ilie N (2012) The mechanical stability of nano-hybrid composites with new methacrylate monomers for matrix compositions. Dent Mater 28:152–159
Grantham SG, Siviour CR, Proud WG, Field JE (2004) High-strain rate Brazilian testing of an explosive simulant using speckle metrology. Meas Sci Technol 15:1867–1870
Chuang S-F, Chang C-H, Chen TY-F (1963) Contraction behaviors of dental composite restorations—finite element investigation with DIC validation
Acknowledgement
This work is supported by National Science Council, Republic of China under the contract no. NSC-101-2320-B-006 -003 –MY2.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2015 The Society for Experimental Mechanics, Inc.
About this paper
Cite this paper
Chen, T.Y., Hsu, C.L., Chuang, S.F. (2015). Characterization of Time-Dependent Mechanical Behaviors of Dental Composites by DIC. In: Jin, H., Sciammarella, C., Yoshida, S., Lamberti, L. (eds) Advancement of Optical Methods in Experimental Mechanics, Volume 3. Conference Proceedings of the Society for Experimental Mechanics Series. Springer, Cham. https://doi.org/10.1007/978-3-319-06986-9_21
Download citation
DOI: https://doi.org/10.1007/978-3-319-06986-9_21
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-06985-2
Online ISBN: 978-3-319-06986-9
eBook Packages: EngineeringEngineering (R0)