Abstract
In many data evaluation procedures for particle measuring devices and in filtration models, spherical particles are assumed. However, significant fractions of aerosol particles are agglomerates of small primary spheres. The morphology of particles in filtration processes may not be known a priori and if the filtration data are processed with wrong assumption, errors can be induced. In this work, we have quantified such errors for the case of open-structured agglomerates. Filtration efficiency tests with polydisperse silver nanoparticle agglomerates and their sintered spheres were performed. After the sintering process, particles with a compact structure with the shape close to a sphere are obtained, which are referred to as sintered spheres in the present study. The testing method involved generation of particulate forms, passing the particles through the testing section, and measurement of the particle number concentrations and size distributions before and after the filter. Measurements of the aerosols upstream and downstream of the filter were conducted using scanning mobility particle sizers (SMPS, TSI Inc.), which covered the rage from 10 to 480 nm. Particles were additionally characterized from the electron microscopic images and the average primary particle size was determined to be 16.8 nm. The number-size distribution curves were obtained and used for penetration calculation. The penetration was dependent on the particle size and morphology. Silver-sintered spheres were captured with a lower efficiency than agglomerates with the same mobility diameter because of the stronger interception effect for agglomerates. Data analysis of the number-size distribution for agglomerates was processed based on sphere assumption and using the model for open-structured agglomerates developed by Lall and Friedlander. The efficiencies based on total concentrations of number, surface and volume were affected when the agglomerate model was used. The effect was weakest for the total number efficiency and strongest for the total volume efficiency. Filtration efficiency curves for agglomerates were additionally plotted as a function of the volume equivalent diameter or number of primary particles per agglomerate, because the latter parameters provide more information for the agglomerate structure.
This article is part of the Topical Collection on Nanotechnology for Sustainable Development
Preview
Unable to display preview. Download preview PDF.
References
Cai J, Sorensen CM (1994) Diffusion of fractal aggregates in the free molecular regime. Phys Rev E 50(5):3397–3400
Cena LG, Ku BK, Peters TM (2012) Particle collection efficiency for nylon mesh screens. Aerosol Sci Technol 46(2):214–221. doi:10.1080/02786826.2011.617401
Fu T-H, Cheng M-T, Shaw DT (1990) Filtration of chain aggregate aerosols by model screen filter. Aerosol Sci Technol 13(2):151–161. doi:10.1080/02786829008959433
Japuntich DA, Franklin LM, Pui DY, Kuehn TH, Kim S, Viner AS (2007) A comparison of two nano-sized particle air filtration tests in the diameter range of 10 to 400 nanometers. J Nanopart Res 9:93–107. doi:10.1007/978-1-4020-5859-2_10
Kim SC, Wang J, Emery MS, Shin WG, Mulholland GW, Pui DYH (2009a) Structural property effect of nanoparticle agglomerates on particle penetration through fibrous filter. Aerosol Sci Technol 43(4):344–355. doi:10.1080/02786820802653763
Kim SC, Wang J, Shin WG, Scheckman JH, Pui DYH (2009b) Structural properties and filter loading characteristics of soot agglomerates. Aerosol Sci Technol 43(10):1033–1041. doi:10.1080/02786820903131081
Kousaka Y, Endo Y, Ichitsubo H, Alonso M (1996) Orientation-specific dynamic shape factors for doublets and triplets of spheres in the transition regime. Aerosol Sci Technol 24(1):36–44
Ku BK, Maynard AD (2006) Generation and investigation of airborne silver nanoparticles with specific size and morphology by homogeneous nucleation, coagulation and sintering. J Aerosol Sci 37(4):452–470. doi:10.1016/j.jaerosci.2005.05.003
Lall AA, Friedlander SK (2006) On-line measurement of ultrafine aggregate surface area and volume distributions by electrical mobility analysis: I. Theoretical analysis. J Aerosol Sci 37(3):260–271. doi:10.1016/j.jaerosci.2005.05.021
Lall AA, Seipenbusch M, Rong W, Friedlander SK (2006) On-line measurement of ultrafine aggregate surface area and volume distributions by electrical mobility analysis: II. comparison of measurements and theory. J Aerosol Sci 37(3):272–282. doi:10.1016/j.jaerosci.2006.01.006
Lange R, Fissan H, Schmidt-Ott A (1999) Predicting the collection efficiency of agglomerates in fibrous filters. Part Part Syst Charact 16(2):60–65. doi:10.1002/(sici)1521-4117(199906)16:2<60:aid-ppsc60>3.0.co;2-a
Lange R, Fissan H, Schmidt-Ott A (2000) A new method for the determination of the interception equivalent diameter. J Aerosol Sci 31(2):221–231. doi:10.1016/s0021-8502(99)00050-6
Oberdörster G, Oberdörster E, Oberdörster J (2005) Nanotoxicology: an emerging discipline evolving from studies of ultrafine particles. Environ Health Perspect 113(7):823–839. doi:10.1289/ehp.7339
Park K, Kittelson DB, McMurry PH (2004) Structural properties of diesel exhaust particles measured by transmission electron microscopy (TEM): relationships to particle mass and mobility. Aerosol Sci Technol 38(9):881–889. doi:10.1080/027868290505189
Schmidt-Ott A (1988) New approaches to in situ characterization of ultrafine agglomerates. J Aerosol Sci 19(5):553–563. doi:10.1016/0021-8502(88)90207-8
Shin W, Wang J, Mertler M, Sachweh B, Fissan H, Pui D (2009a) Structural properties of silver nanoparticle agglomerates based on transmission electron microscopy: relationship to particle mobility analysis. J Nanopart Res 11(1):163–173. doi:10.1007/s11051-008-9468-y
Shin WG, Mulholland GW, Kim SC, Wang J, Emery MS, Pui DYH (2009b) Friction coefficient and mass of silver agglomerates in the transition regime. J Aerosol Sci 40(7):573–587. doi:10.1016/j.jaerosci.2009.02.006
Shin WG, Wang J, Mertler M, Sachweh B, Fissan H, Pui DYH (2010) The effect of particle morphology on unipolar diffusion charging of nanoparticle agglomerates in the transition regime. J Aerosol Sci 41(11):975–986. doi:10.1016/j.jaerosci.2010.07.004
Song CB, Park HS (2006) Analytic solutions for filtration of polydisperse aerosols in fibrous filter. Powder Technol 170(2):64–70. doi:10.1016/j.powtec.2006.08.011
Song DK, Lenggoro IW, Hayashi Y, Okuyama K, Kim SS (2005) Changes in the shape and mobility of colloidal gold nanorods with electrospray and differential mobility analyzer methods. Langmuir 21(23):10375–10382. doi:10.1021/la0513196
Sorensen CM (2011) The mobility of fractal aggregates: a review. Aerosol Sci Technol 45(7):765–779. doi:10.1080/02786826.2011.560909
Stanley N, Qi C, Pui DYH (2010) a new method of filter efficiency evaluation using the nanoparticle surface area monitor (NSAM) for a nanoparticle health relevant filter efficiency measure. Filtration 10(1):40–46
Wang GM, Sorensen CM (1999) Diffusive mobility of fractal aggregates over the entire knudsen number range. Phys Rev E 60(3):3036–3044
Wang J, Kim SC, Pui DYH (2008a) Figure of merit of composite filters with micrometer and nanometer fibers. Aerosol Sci Technol 42(9):722–728. doi:10.1080/02786820802249133
Wang J, Kim SC, Pui DYH (2008b) Investigation of the figure of merit for filters with a single nanofiber layer on a substrate. J Aerosol Sci 39(4):323–334. doi:10.1016/j.jaerosci.2007.12.003
Wang J, Shin WG, Mertler M, Sachweh B, Fissan H, Pui DYH (2010) Measurement of nanoparticle agglomerates by combined measurement of electrical mobility and unipolar charging properties. Aerosol Sci Technol 44(2):97–108. doi:10.1080/02786820903401427
Wang J, Kim SC, Pui DYH (2011) Carbon nanotube penetration through a screen filter: numerical modeling and comparison with experiments. Aerosol Sci Technol 45(3):443–452. doi:10.1080/02786826.2010.541531
Wen HY, Reischl GP, Kasper G (1984) Bipolar diffusion charging of fibrous aerosol particles—I. Charging theory. J Aerosol Sci 15(2):89–101. doi:10.1016/0021-8502(84)90029-6
Zelenyuk A, Imre D (2007) On the effect of particle alignment in the DMA. Aerosol Sci Technol 41(2):112–124. doi:10.1080/02786820601118380
Acknowledgments
Financial support by the European Committee for Standardization in the frame of mandate M/461 “Standardization activities regarding nanotechnologies and nanomaterials” is acknowledged. The authors also thank the support of members of the Center for Filtration Research: 3M, Boeing Commercial Airplanes, Cummins Filtration, Donaldson Co., Inc., Entegris, Inc., Hollingsworth & Vose Co., MANN + HUMMEL, GMBH, MSP Corp., Samsung Electronics Co., Ltd, Shigematsu Works Co., Ltd, TSI Inc., and W. L. Gore & Associates, Inc. and affiliate member NIOSH.
Author information
Authors and Affiliations
Corresponding authors
Editor information
Editors and Affiliations
Additional information
Special Issue Editors: Mamadou Diallo, Neil Fromer, Myung S. Jhon
Rights and permissions
Copyright information
© 2013 Springer Science+Business Media Dordrecht
About this paper
Cite this paper
Buha, J., Fissan, H., Wang, J. (2013). Filtration behavior of silver nanoparticle agglomerates and effects of the agglomerate model in data analysis. In: Diallo, M.S., Fromer, N.A., Jhon, M.S. (eds) Nanotechnology for Sustainable Development. Springer, Cham. https://doi.org/10.1007/978-3-319-05041-6_29
Download citation
DOI: https://doi.org/10.1007/978-3-319-05041-6_29
Received:
Accepted:
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-05040-9
Online ISBN: 978-3-319-05041-6
eBook Packages: Chemistry and Materials ScienceChemistry and Material Science (R0)