Advertisement

Erratum to: Characterization of Carbon Nanotube-Based Composites Under Consideration of Defects

  • Moones RahmandoustEmail author
  • Majid R. Ayatollahi
Erratum
Part of the Advanced Structured Materials book series (STRUCTMAT, volume 39)

Keywords

Carbon Nanotube-based Composites Original Chapter Advanced Structural Materials Scientists Worldwide Helpful Guidance 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Erratum to: M. Rahmandoust and M.R. Ayatollahi, Characterization of Carbon Nanotube-Based Composites Under Consideration of Defects, Advanced Structured Materials 39, DOI  10.1007/978-3-319-00251-4

Preface:

The last paragraph of the preface has been modified as below.

Finally, we appreciate the moment to express our sincere gratitude to Professor Dr.-Ing. Andreas Öchsner, editor-in-chief of the Springer book series on “Advanced Structured Materials” for his helpful guidance. We would like to thank Dr. Shahin Shadlou, Dr. Mohsen Khalily, Mr. Iman Eslami Afrouz, Mr. Mehdi Mavalizadeh, Mr. Morteza Farsadi, Mr. Ali Ghavamian and Mr. Reza Barbaz for their valuable assistance. Dr. Mostafa Rahmandoust, Mrs. Azar Rezaie and Dr. Hamidreza Kazempour should also be appreciated here for their kind support. In conclusion, we are grateful to many scientists worldwide, for their novel contributions to the topic, and for devoting their lives to keep the flame of knowledge and science burning brightly and beautifully through human history. We also thank Springer publisher for recognizing the necessity of the topic and the importance of characterization of defects in nanostructured materials.

Chapter 4: Revised Figures

The legends for the figures 4.9, 4.11, 4.16, 4.24 were incomplete in chapter 4. The missed out legends have been completed and updated in the original chapter.
Fig. 4.9

Typical force-displacement curves obtained for pure epoxy and for nanocomposites under mode I loading conditions (Ayatollahi et al. 2011f)

Fig. 4.11

Mixed mode I/II fracture toughness data obtained for pure epoxy and for nanocomposites (Ayatollahi et al. 2011f)

Fig. 4.16

Effects of MWCNT aspect ratio on mixed mode I/II fracture toughness data obtained for pure epoxy and for nanocomposites (Ayatollahi et al. 2011g)

Fig. 4.24

Apparent and ploughing coefficients of friction in terms of MWCNT percent content (Ayatollahi et al. 2012a)

Chapter 5: Revised Figure

The legends for the figure 5.10 were incomplete in chapter 5. The missed out legends have been completed and updated in the original chapter.
Fig. 5.10

Experimental results obtained for the tensile behavior of various UD-laminates tested in the fiber direction. a The tensile modulus, b failure strength, c stress versus strain curves (Godara et al. 2009)

Copyright information

© Springer International Publishing Switzerland 2016

Authors and Affiliations

  1. 1.Griffith School of EngineeringGriffith University (Gold Coast Campus)SouthportAustralia
  2. 2.Protein Research CenterShahid Beheshti University, G.C.TehranIran
  3. 3.Fatigue and Fracture Research Laboratory, Center of Excellence in Experimental Solid Mechanics and Dynamics, School of Mechanical EngineeringIran University of Science and TechnologyTehranIran

Personalised recommendations