Abstract
The values of uniformly estimated apparent stress σ a, and Brune’s stress drop, taken as a measure of static stress drop, from 850 seismic events, with moment magnitude ranging from −3.6 to 3.6, induced at the Underground Research Laboratory (URL) in Canada, Western Deep Levels (WDL) gold mine in South Africa, and two coal and two copper mines in Poland, were collected to study the stress release mode in various mining environments. For this, the quantity epsilon, ε = Βσ/(σ a + Βσ/2), where Au is the static stress drop, proposed by Zūñiga (1993) as an indicator of stress-drop mechanism was used. The events induced at the URL are characterized by low values of epsilon corresponding to a partial stress drop mechanism, whereas all the events at WDL display a frictional overshoot mechanism in which final stress reaches a lower value than that of frictional stress. The events at Polish coal and copper mines, on the other hand, are in good agreement with the well-known Orowan’s condition such that the final stress is equal to the dynamic frictional stress.
The Brune stress drop, however, is heavily model dependent through the source radius-corner frequency relation. The Orowan’s condition for the events from the URL would be met if a constant in the source radius-corner frequency relation is equal to 1.82 ± 0.12, and for the events from WDL if it is equal to 3.92 ± 0.40, in contrast to Brune’s constant of 2.34.
The smoothed values of epsilon displayed as a function of time, represented by the consecutive event numbers, for selected sets of events imply that the largest seismic events in a given set occur when the epsilon is low and a partial stress drop mechanism is dominant. The large events are then followed by high epsilon values when a frictional overshoot mechanism begins to dominate.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
References
Boatwright, J. (1984) Seismic Estimates of Stress Release, J. Geophys. Res. 89,6961–6968.
Brune, J. N. (1970), Tectonic Stress and the Spectra of Seismic Shear Waves from Earthquakes J. Geophys. Res. 75, 4997–5009.
Brune, J. N. (1971), Correction, J. Geophys. Res. 76,5002.
Brune, J. N. The physics of earthquake strong motion. In Seismic Risk and Engineering Decisions (eds. Lomnitz, C., and Rosenblueth, E.) (Elsevier, New York 1976) pp. 141–177.
Castro, R. R., Pacor, F., and Petrungaro, C. (1997), Determination of S-wave Energy Release of Earthquakes in the Region of Friuli, Italy,Geophys. J. Int. 128, 399–408.
Deichmann, N. (1997), Far-field Pulse Shapes from Circular Sources with Variable Rupture Velocities, Bull. Seismol. Soc. Am. 87, 1288–1296.
Feignier, B., and Young, R. P. (1992), Moment Tensor Inversion of Induced Microseismic Events: Evidence of Non-shearing Failures in the —4 < M < — 2 Moment Magnitude Range, Geophys. Res. Lett. 19, 1503–1506.
Gtsowicz, S. J., The mechanism of large mining tremors in Poland. In Rockbursts and Seismicity in Mines (eds. Gay, N. C., and Wainwright, E. H.) (South African Institute of Mining and Metallurgy, Johannesburg 1984) pp. 17–28.
Gtsowicz, S. J. (1995), Scaling Relations for Seismic Events Induced by Mining, Pure appl. geophys. 144,191–209.
Gibowicz, S. J. (1996), Relations between Source Mechanism and the Ratio of S- over P-wave Energy for Seismic Events Induced by Mining, Acta Montana, Ser. A. 9 (100), 7–15.
Gibowicz, S. J. (1997a), Scaling Relations for Seismic Events at Polish Copper Mines, Acta Geophys. Pol. 45, 169–181.
Gibowicz, S. J. (1997b), An Anatomy of a Seismic Sequence in a Deep Gold Mine, Pure appl. geophys. 150, 393–414.
Gisowtcz, S. J., and Kijko, A., An Introduction to Mining Seismology (Academic Press, San Diego 1994).
Gibowicz, S. J., Harjes, H.-P., and Schafer, M. (1990), Source Parameters of Seismic Events at Heinrich Robert Mine, Ruhr Basin, Federal Republic of Germany: Evidence for Nondouble-Couple Events, Bull. Seismol. Soc. Am. 80,88–109.
Gjbowicz, S. J., Young, R. P., Talebi, S., and Rawlence, D. J. (1991), Source Parameters of Seismic Events at the Underground Research Laboratory in Manitoba, Canada: Scaling Relations for Events with Moment Magnitude Smaller than —2, Bull. Seismol. Soc. Am. 81,1157–1182.
Madariaga, R. (1976), Dynamics of an Expanding Circular Fault, Bull. Seismol. Soc. Am. 66, 639–666.
Mcgarr, A., Some applications of seismic source mechanism studies to assessing underground hazard. In Rockbursts and Seismicity in Mines (eds. Gay, N. C., and Wainwright, E. H.) (South African Institute of Mining and Metallurgy, Johannesburg 1984) pp. 199–208.
Mcgarr, A. (1991), Observations Constraining Near-source Ground Motion Estimated from Locally Recorded Seismograms, J. Geophys. Res. 96,16,495–508.
Mcgarr, A. (1992a), An Implosive Component in the Seismic Moment Tensor of a Mining-induced Tremor, Geophys. Res. Lett. 19, 1579–1582.
Mcgarr, A. (1992b), Moment Tensors of Ten Witwatersrand Mine Tremors, Pure appl. geophys. 139,781–800.
Mcgarr, A. (1994), Some Comparisons between Mining-induced and Laboratory Earthquakes, Pure appl. geophys. 142, 467–489.
Mendecki, A. J., Principles of monitoring seismic rockmass response to mining. In Rockbursts and Seismicity in Mines (eds. Gibowicz, S. J., and Lasocki, S.) (Balkema, Rotterdam 1997) pp. 69–80.
Orowan, E. (1960), Mechanism of Seismic Faulting in Rock Deformation, Geol. Soc. Am. Mem. 79,323–345.
Revalor, R., Josien, J. P., Besson, J. L., and Magron, A., Seismic and seismoacoustic experiments applied to the prediction of rockbursts in French coal mines. In Rockbursts and Seismicity in Mines (ed. Fairhurst, C.) (Balkema, Rotterdam 1990) pp. 301–306.
Sato, K., and Fujh, Y. (1989), Source Mechanism of a Large-scale Gas Outburst at Sunagawa Coal Mine in Japan,Pure appl. geophys. 129,325–343.
Sato, T., and Hirasawa, T. (1973), Body Wave Spectra from Propagating Shear Cracks, J. Phys. Earth 21, 415–431.
Savage, J. C., and Wood, M. D. (1971), The Relation between Apparent Stress and Stress Drop, Bull. Seismol. Soc. Am. 61, 1381–1388.
Smith, K. D., Brune, J. N., and Priestly, K. F. (1991), The Seismic Spectrum, Radiated Energy, and the Savage and Wood Inequality for Complex Earthquakes, Tectonophysics 188, 303–320.
Snoke, J. A. (1987), Stable Determination of (Brune) Stress Drops, Bull Seismol. Soc. Am. 77, 530–538.
Snoke, J. A., Linde, A. T., and Sacks, I. S. (1983), Apparent Stress: An Estimate of the Stress Drop,Bull. Seismol. Soc. Am. 73, 339–348.
Wiejacz, P. (1992), Calculation of Seismic Moment Tensor for Mine Tremors from the Legnica-Glogow Copper Basin, Acta Geophys. Pol. 40, 103–122.
Wiejacz, P., Moment tensors for seismic events from Upper Silesian coal mines, Poland. In Mechanics of Jointed and Faulted Rock (ed. Rossmanith, H.-P.) (Balkema, Rotterdam 1995) pp. 667–672.
Wyss, M. (1970), Stress Estimates of South American Shallow and Deep Earthquakes, J. Geophys. Res. 75, 1529–1544.
Zūñiga, F. R. (1993), Frictional Overshoot and Partial Stress Drop. Which One?, Bull. Seismol. Soc. Am. 83, 939–944.(Received March 23, 1998, revised June 30, 1998, accepted July 15, 1998)
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 1998 Springer Basel AG
About this chapter
Cite this chapter
Gibowicz, S.J. (1998). Partial Stress Drop and Frictional Overshoot Mechanism of Seismic Events Induced by Mining. In: Talebi, S. (eds) Seismicity Caused by Mines, Fluid Injections, Reservoirs, and Oil Extraction. Pageoph Topical Volumes. Birkhäuser, Basel. https://doi.org/10.1007/978-3-0348-8804-2_2
Download citation
DOI: https://doi.org/10.1007/978-3-0348-8804-2_2
Publisher Name: Birkhäuser, Basel
Print ISBN: 978-3-7643-6048-1
Online ISBN: 978-3-0348-8804-2
eBook Packages: Springer Book Archive