Abstract
This paper presents an experience in application of electrical equipment condition estimation. With the transition to the system of the electrical equipment repair to condition-based maintenance (c) system and the introduction of the system of planning the resources of enterprise in FGC UES Company planning measures for maintenance and repair of electrical equipment rose to qualitatively different level and, as consequence increased the requirements, presented to the estimation of equipment state.
Diagnostics specialists faced a complex of issues, without solution of which was impossible the realization of all effective tools of the productive system automatic control system (ASU) of maintenance and repair and final transition to CBM repair system.
The task lies in the fact that it is possible to decrease, or exclude faults with the use of information tools. By information tool in this work is implied software, located on a stationary PC or a laptop. As a whole by information tool it is possible to understand the specialized automated working place (further SAWP).
To make decisions such as to evaluating controlling influences can be only based on the estimation of technical condition state (TCS).
In the article the general relationship of errors is examined in those influencing the quality of the estimation of the technical condition state of electrical equipment and so the way of their decrease and of the eliminations of reasons, which cause errors. The use of special information tools (software) will make it possible to considerably decrease the subjective errors, which appear in the process TCS electrical equipment.
Making a decision about development and introduction in FGC Company of the tools of similar SAWP is extremely necessary, since TCS has a significant effect on the total effectiveness of company.
This is a preview of subscription content, log in via an institution to check access.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Fogelberg, T., Girgis, R.S.: ABB power transformers-a result of merging different technologies with prospects for significant future advancements. In: International Symposium “Electrotechnics-2010”, Moscow, no. 1 (1994)
Khrennikov, A.Yu.: Power transformer’s fault diagnostics at SAMARAENERGO Co, including FRA/LVI method. Reports from School of Math. and System Engineering, Vaxjo University, Sweden N43 (2000). ISSN: 1400-1942
Malewski, R., Khrennikov, A.Yu.: Monitoring of winding displacements in HV transformers in service, pp. 4–9. CIGRE Working Group 33.03, Italy (1995)
Lech, W., Tyminski, L.: Detecting transformer winding damage-the low voltage impulse method. Electr. Rev. 179, 768–772 (1966)
Khrennikov, A.Yu.: Diagnostics of electrical equipment’s faults, defects and weaknesses. In: Reports of Conference on Condition Monitoring and Diagnosis (CMD 2006), Korea (2006)
Khrennikov, A.Yu.: New “intellectual networks” (Smart Grid) for detecting electrical equipment faults, defects and weaknesses. Smart Grid Renew. Energy 3(03), 159 (2012)
Khrennikov, A.Yu.: Smart Grid technologies for detecting electrical equipment faults, defects and weaknesses. In: Workshop on Mathematical Modelling of Wave Phenomena with Applications in the Power industry, Linnaeus University, Växjö (2013). http://lnu.se/mmwp
Khrennikov, A.Yu., Shakaryan, Y.G., Dementyev, Y.A.: Shortcurrent testing laboratories. Short-circuit performance of power transformers, transformer testing experience. Int. J. Autom. Control Eng. (IJACE). 2(3), 120–127 (2013). http://www.seipub.org/ijace/AllIssues.aspx
Khrennikov, A.Yu., Mazhurin, R.V., Radin, P.S.: Infra-red and ultraviolet control, LVI-testing, partial discharges and another diagnostic methods for detection of electrical equipment’s faults, defects. J. Multidiscip. Eng. Sci. Technol. (JMEST) 1(4) (2014). http://www.jmest.org/vol-1-issue-4-november-2014/. ISSN: 3159-0040
Khrennikov, A.Yu.: Diagnostics of Electrical Equipment Faults and Power Overhead Transmission Line Condition by Monitoring Systems (Smart Grid): Short-Circuit Testing of Power Transformers, 174 p. Nova publishers, New York (2016). https://www.novapublishers.com/catalog/product_info.php?products_id=56561
Acknowledgment
Mr. Richard Malewski, Poland, Mr. John Lapworth, Great Britain, are greatly acknowledged for supporting this study. Cooperation of Universities and Innovation Development, Doctoral School project “Complex diagnostic modeling of technical parameters of power transformer-reactor electrical equipment condition” has made publishing of this article possible.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2020 Springer Nature Switzerland AG
About this paper
Cite this paper
Khrennikov, A.Y., Aleksandrov, N.M., Radin, P.S. (2020). Dependability of Service of Substation Electrical Equipment: Estimation of the Technical Condition State with the Use of Software and Information Tools. In: Zamojski, W., Mazurkiewicz, J., Sugier, J., Walkowiak, T., Kacprzyk, J. (eds) Engineering in Dependability of Computer Systems and Networks. DepCoS-RELCOMEX 2019. Advances in Intelligent Systems and Computing, vol 987. Springer, Cham. https://doi.org/10.1007/978-3-030-19501-4_27
Download citation
DOI: https://doi.org/10.1007/978-3-030-19501-4_27
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-030-19500-7
Online ISBN: 978-3-030-19501-4
eBook Packages: Intelligent Technologies and RoboticsIntelligent Technologies and Robotics (R0)