Advertisement

Typical Printer Settings

  • Joan Horvath
Chapter

Abstract

Several chapters in this book, most notably Chapters 5 and 8, discuss settings for slicing a file. If you use Slic3r, you may be intimidated by all the settings you see in the Configure panel. The Slic3r manual ( http://manual.slic3r.org/ ) defines all these in detail, and we will not reproduce those definitions here.

Keywords

Open Source Software Layer Height Nominal Diameter Matter Control Filament Parameter 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Copyright information

© Joan Horvath 2014

Authors and Affiliations

  • Joan Horvath
    • 1
  1. 1.CAUS

Personalised recommendations