Advertisement

Correlating the Slagging of a Utility Boiler with Coal Characteristics

  • Rod Hatt

Abstract

This paper will describe how a utility was able to correlate intermittent slagging problems a boiler was experiencing with coal ash chemistry. The coal ash fusion temperatures alone were not sufficient to be able to separate the good versus poor performing coals. Further investigation revealed that the iron levels in the coal ash, and several indexes such as Base to Acid ratio, slagging factor and iron loading provided good bases for separating the coals that caused problems and those that did not. A total of nine coal supplies were burned in the boiler of which four caused furnace slagging problems. This utility experience further demonstrates the value of the ash chemistry data and the necessity of including more data than the fusion temperatures in coal specifications. The split between successful and unsuccessful coals is specific to this plant and should not be used universally. This work does demonstrate that ash chemistry can provide information for determining weather or not a coal can be successfully used at this plant.

Keywords

Iron Loading Fusion Temperature Utility Boiler Coal Characteristic Silica Percentage 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. 1.
    ASME ASH FUSION RESEARCH PROJECT, CRTD-18, For availability contact: ASTM/CRTD, 1828 L St. NW, Suite 906, Washington DC 20036.Google Scholar
  2. 2.
    Annual Book of ASTM Standards, Vol. 5.05 Gaseous Fuels; Coal and Coke, ASTM 1916 Race Street, Philadelphia, PA 19103–1187, USA.Google Scholar
  3. 3.
    Reid, W.T. and Cohen, P. “The flow characteristics of coal ash slags in the solidification range” Jour. Eng. Power, Trans. ASME Series A, 66, 83, 1944.Google Scholar
  4. 4.
    Winegartner, E. C. (ed.). Coal Fouling and Slagging Parameters. ASME research Committee on Corrosion and Deposits from Combustion Gases, ASME pub.,1974.Google Scholar
  5. 5.
    Attig, R. C. and Duzy, A. F., “Coal ash depositional studies and application to boiler design” Amer. Power Conf., Chicago, Ill., Illinois Institute of Technology, 1969.Google Scholar

Copyright information

© Springer Science+Business Media New York 1996

Authors and Affiliations

  • Rod Hatt
    • 1
  1. 1.Commercial Testing & Engineering Co.LexingtonUSA

Personalised recommendations