Advertisement

Computer technology

  • D. A. Milner
  • V. C. Vasiliou

Abstract

Computer applications in manufacturing companies are now widespread. Due to the development of very large scale integration (VLSI) and the potential for even higher scale integration which could go up to millions of transistors per chip, computers have become more sophisticated, more powerful and cheaper. In the present competitive commercial environment, the use of computer technology in the manufacture of parts and production processes is perhaps the most promising method for increasing productivity and financial gain.

Keywords

Machine Tool Adaptive Control Very Large Scale Integration Metal Removal Rate Part Program 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. Centner, R.M.; Idelsohn, J.M. Adaptive controller and performance measurement of the milling process. IEEE Trans on Application and Industry 1964, Vol. 83 (72), pp. 154–161.CrossRefGoogle Scholar
  2. Childs, J.J. Numerical Control Part Programming Industrial Press, New York, 1973.Google Scholar
  3. Crossley, T.R. A decade of direct numerical control. Annals of the CIRP 1978, Vol. 27 (1), pp. 405–408.Google Scholar
  4. Essel, K. Adaptive Control of the Turning Process Dr-Ing. Thesis, Technische Hochschule, Aachen, Germany, 1972.Google Scholar
  5. IBM System 370 APT-AC Numerical Control Program Reference Manual Vol. I, Program S-740-M53, 1972.Google Scholar
  6. Illinois Institute of Technology Research Institute (IITRI) APT Part Programming McGraw Hill, New York, 1967.Google Scholar
  7. Milner, D.A. An introduction to adaptive control. The Production Engineer March 1975, p. 175.Google Scholar
  8. Ollston, N.D. Numerical Control Wiley Interscience, New York, 1970.Google Scholar
  9. Pressman, R.S.; Williams, J.E. Numerical Control and Computer Aided Manufacturing John Wiley, New York, 1977.Google Scholar
  10. Spur, G.; Wentz, W. A system for direct numerical control of machine tools. In Proc. of 12th Int. MTDR Conf. Manchester, 1971.Google Scholar
  11. Stockmann, P. Advanced computer programming for turning developments in automatic turning machines. The Production Engineer 27th February, 1974.Google Scholar
  12. Stute, G.; Nann, R. Report on a special DNC system. In Proc. of 12th Int. MTDR Conf. Manchester, 1971.Google Scholar
  13. Takeyana, H. et al. Sensors of tool life for optimization machining. In Proc. of 7th Int. MTDR Conf. Manchester, 1967.Google Scholar
  14. Tipton, H.; Roberts, J.I. The MTIRA computer numerical control system. In Proc. 14th Int. MTDR Conf. Manchester, 1973.Google Scholar
  15. Wilson, G.E. In-process measurement of tool wear on a milling cutter. Machine Tool Ind. Res. Assoc. 1970 (Paper 7), Appendix A2, pp. 17–19.Google Scholar
  16. Wu, S.M.; Ermer, D.S. Maximum profit as the criterion in the determination of optimum machining conditions. Am. Soc. Mech., J. of Eng. for Ind. November 1960, Vol. 88, pp. 435–442.Google Scholar

Copyright information

© D A Milner and V C Vasiliou 1986

Authors and Affiliations

  • D. A. Milner
  • V. C. Vasiliou

There are no affiliations available

Personalised recommendations