A Theoretical Review of Particle Adhesion

  • R. Allen Bowling


This paper constitutes a theoretical review of the forces of adhesion of small particles to surfaces. The primary force of adhesion of small, less than 50 micron diameter, particles on a dry surface are van der Waals forces. These van der Waals forces can be increased due to particle and/or surface deformations which increase the particle contact area. Particles less than 1 micron diameter can be held to surfaces by forces exceeding 100 dynes, which corresponds to forces per unit area of 109 dyn/cm2 or more. Total forces of adhesion for 1 micron diameter particles can exceed the gravitational force acting on that particle by factors greater than 106. Electrostatic forces, although they only become important and predominate for particles larger than 50 microns diameter, may play a significant role in bringing particles to surfaces for adhesion. The presence of a liquid between the particle and surface, due to either immersion and subsequent removal from a liquid or due to high humidity conditions, can add a very large capillary force to the total force of adhesion. This capillary force is known to remain, in some cases, even after baking at above the liquid boiling point for many hours. Although some possibilities exist for particle removal, removal of small particles has been in practice extremely difficult due to these large forces. Each of these forces will be discussed theoretically with some attempts at quantification versus particle diameter. Some data will also be presented on attempted particle removal as a function of removal method. Clearly, emphasis should be placed on prevention of particle deposition on surfaces rather than relying on achieving subsequent removal.


Electrostatic Force Capillary Force Adhesion Force Total Force Contact Potential Difference 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.


Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.


  1. 1.
    J. M. Duffalo, and J. R. Monkowski, Solid State Technol., 27 (3), 109(1984).Google Scholar
  2. 2.
    M. Corn, J. Air Pollution Control Assoc, 11 (11), 523 (1961).Google Scholar
  3. 3.
    M. Corn, J. Air Pollution Control Assoc, 11 (12), 523 (1961).Google Scholar
  4. 4.
    J. Visser, Surf. Colloid. Sci., 8,3 (1975).Google Scholar
  5. 5.
    H. Krupp, Adv. Colloid Interface Sci., 1 (2), 111 (1967).CrossRefGoogle Scholar
  6. 6.
    S. Bhattacharya, and K. L. Mittal, Surf. Technol., 7, 413 (1978).CrossRefGoogle Scholar
  7. 7.
    W. Kern and D. A. Puotinen, RCA Rev., 31, 187 (1970).Google Scholar
  8. 8.
    R. K. Iler, The Colloid Chemistry of Silica and Silicates, p. 95, Cornell University Press, Ithaca, New York, 1955.Google Scholar
  9. 9.
    R. A. Bowling, J. Electrochem. Soc, 132, 2208 (1985).CrossRefGoogle Scholar
  10. 10.
    M. Corn, in Aerosol Science, C. N. Davies, Editor, p. 359, Academic Press, New York, 1966.Google Scholar
  11. 11.
    F. London, Z. Phys., 63, 245 (1930).CrossRefGoogle Scholar
  12. 12.
    F. London, Trans. Faraday. Soc, 33, 8 (1937).CrossRefGoogle Scholar
  13. 13.
    H. C.Hamaker, Physica, 4, 1058 (1937).CrossRefGoogle Scholar
  14. 14.
    H. Rumpf, in Agglomeration 77, Proc of the Second Internat. Symp. on Agglomeration, Vol. 1, p. 97, K. V. S. Sastry, Editor, American Institute of Mining, Metallurgical, and Petroleum Engineers, Inc., New York, 1977.Google Scholar
  15. 15.
    J. A. Kitchener, J. Soc. Cosmet. Chem., 24, 709 (1973).Google Scholar
  16. 16.
    E. M. Lifshitz, Sov. Phys. JETP, 2, 73 (1956).Google Scholar
  17. 17.
    B. B. Morgan, The British Coal Utilization Research Assoc. Monthly Bulletin, 25(4), 125(1961).Google Scholar
  18. 18.
    B. V. Deryagin, and A. D. Zimon, Colloid. J. USSR, 23, 454 (1961).Google Scholar
  19. 19.
    E. J. Clayfield and E. C. Lamb, Disc. Faraday Soc., 42, 285 (1966).CrossRefGoogle Scholar
  20. 20.
    C. Tipton, (1986) personal communication.Google Scholar
  21. 21.
    B. Y. H. Liu, Editor, Fine Particles, Academic Press, London, 1976.Google Scholar
  22. 22.
    N. A. Fuchs, The Mechanics of Aerosols, MacMillan Co., New York, 1964.Google Scholar
  23. 23.
    C. N. Davies, Editor, Air Filtration, Academic Press, London, 1973.Google Scholar
  24. 24.
    R. G. Dorman, in Aerosol Science, C. N. Davies, Editor, p. 195, Academic Press, New York, 1966.Google Scholar
  25. 25.
    S. N. Omenyi, J. Chappuis, and A. W. Neumann, J. Adhesion, 13, 131 (1981).CrossRefGoogle Scholar
  26. 26.
    D. Bargema, and F. Van Voorst Vader, J. Electroanal. Chem. Interfacial Electrochem., 37, 45 (1972).CrossRefGoogle Scholar
  27. 27.
    A. D. Zimon, Adhesion of Dust and Powders, Second Edition, Consultants Bureau, New York, 1982.CrossRefGoogle Scholar
  28. 28.
    B. V. Deryagin, N. A. Krotova, and V. P. Smilga, Adhesion of Solids, Consultants Bureau, New York, 1978.Google Scholar
  29. 29.
    K. L. Mittal, Editor, Surface Contamination: Genesis, Detection, and Control, Volumes 1 and 2, Plenum Press, New York, 1979.Google Scholar

Copyright information

© Plenum Press, New York 1988

Authors and Affiliations

  • R. Allen Bowling
    • 1
  1. 1.Materials Science LaboratoryTexas Instruments IncorporatedDallasUSA

Personalised recommendations