Pressure Relief Radial Passages for SSC

  • Margareta L. Rehak


In the 40 mm SSC cross-section design radial helium venting passages located every 6″ were present. The purpose of these passages was to provide escape routes for helium from the coil cooling passage to the bypasses during a quench. The passages are introduced in the magnet by placing special yoke laminations with channels going from the bypasses to the inner radius.


Maximum Pressure Critical Pressure Brookhaven National Laboratory Helium Pressure Vent Valve 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.


Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Copyright information

© Springer Science+Business Media New York 1992

Authors and Affiliations

  • Margareta L. Rehak
    • 1
  1. 1.Accelerator Development Department Magnet Division BrookhavenNational Laboratory UptonUSA

Personalised recommendations