Electromagnetic Interference (EMI)



Radiated emissions in high-speed DSP systems are caused by fastswitching currents and voltages propagating through printed circuit board traces. As DSP speed increases, printed circuit board traces are becoming more effective antennas, and these antennas are radiating unwanted energies that interfere with other circuitry and with other systems located nearby. This section outlines different ways to design for low EMI and find the root cause of EMI problems when they occur. It only covers the electrical design aspects of EMI even though shielding, cabling and other mechanical fixes can also be used to help reduce the emissions below the maximum allowable limits. In general, mechanical solutions are very expensive for high volume designs. Even worse, the mechanical solutions may have to change when the DSP speed increases.


Ground Plane Electromagnetic Interference Voltage Droop Loop Area Maximum Allowable Limit 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.


Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.


  1. 1.
    Federal Communication Commission (2005) Unintentional Radiators, Title 47 (47CFR), Part 15 B.
  2. 2.
    Montrose Mark (2000) Printed Circuit Board Design Techniques for EMC Compliance. The Institute of Electrical and Electronics Engineers, New York.Google Scholar
  3. 3.
    Montrose Mark (1996) Analysis on the Effectiveness of Image Planes within a Printed Circuit Board. The Institute of Electrical and Electronics Engineers.Google Scholar
  4. 4.
    Ott Henry (1988) Noise Reduction Techniques in Electronic Systems. Prentice-Hall, New Jersey.Google Scholar
  5. 5.
    Johnson, H, Graham, M (2003) High-Speed Signal Propagation. Prentice-Hall, New Jersey.Google Scholar
  6. 6.
    Renolds J (2003) DDR PCB Routing Tutorial. Texas Instruments Inc Tutorial.Google Scholar

Copyright information

© Springer US 2010

Authors and Affiliations

  1. 1.Texas Instruments IncorporatedStaffordUSA

Personalised recommendations