Advertisement

Configuring the Software

  • Charles Bell
Chapter

Abstract

Building a 3D printer and seeing the mechanical bits together for the first time is quite an accomplishment. However, you aren’t done yet. To make the most of your new printer, you need to configure and load the firmware on your printer as well as install software on your computer to control the printer.

Keywords

Stepper Motor Layer Height Menu Item Integrate Development Environment Thread Pitch 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Copyright information

© Charles Bell 2014

Authors and Affiliations

  • Charles Bell
    • 1
  1. 1.VAUS

Personalised recommendations