Abstract
Vacuum infusion process (VIP) has been accepted for composites industry over last decade due to low fabrication cost and applicapability to complex and large composite structures. Vacuum is used as the driving force to impregnate preform with resin [ 1 ]. VIP has been applied to automotive, aerospace, boat, and various industrial fields widely. Process control and the qulity assurance of composites structure are required. Especially resin flow is very important factor in VIP because resin should be impregnated into a preform perfectly without dry spot before starting gelation of resin. Residual stress is generated due to shrinkage of matrix in thermosetting resin during cure. These will be causes of delamination [3] and lower dimensional stability in composite structures. Therefore, control of the manufacturing processes is needed through resin flow monitoring and cure monitoring.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
J. Dai, D. Pellaton, and H.T. Hahn, Polymer composites, vol. 24, no. 6, pp. 672–685, 2003.
J.A. Ramos, N. Pagani, C.C. Riccardi, J. Borrajo, S.N. Goyanes, I. Mondragon, Polymer, vol. 46, pp. 3323–3328, 2005.
H. Igawa, H. Murayama, T. Kasai, I. Yamaguchi, K. Kageyama, and K. Ohta., Proc. ofSPIE, vol. 5855, pp.547–550, 2005.
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2007 Springer
About this paper
Cite this paper
Eum, S. et al. (2007). Process and Health Monitoring Using Fiber Bragg Grating Distributed Sensor for Vacuum Infusion Process. In: Gdoutos, E.E. (eds) Experimental Analysis of Nano and Engineering Materials and Structures. Springer, Dordrecht. https://doi.org/10.1007/978-1-4020-6239-1_55
Download citation
DOI: https://doi.org/10.1007/978-1-4020-6239-1_55
Publisher Name: Springer, Dordrecht
Print ISBN: 978-1-4020-6238-4
Online ISBN: 978-1-4020-6239-1
eBook Packages: EngineeringEngineering (R0)