Advertisement

Design of Reinforced Concrete Beams

  • W. H. Mosley
  • J. H. Bungey
Chapter

Abstract

Reinforced concrete beam design consists primarily of producing member details which will adequately resist the ultimate bending moments, shear forces and torsional moments. At the same time serviceability requirements must be considered to ensure that the member will behave satisfactorily under working loads. It is difficult to separate these two criteria, hence the design procedure consists of a series of interrelated steps and checks. These steps are shown in detail in the flow chart in figure 7.1, but may be condensed into three basic design stages
  1. (1)

    preliminary analysis and member sizing

     
  2. (2)

    detailed analysis and design of reinforcement

     
  3. (3)

    serviceability calculations.

     

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

Copyright information

© W. H. Mosley and J. H. Bungey 1976

Authors and Affiliations

  • W. H. Mosley
    • 1
  • J. H. Bungey
    • 1
  1. 1.Department of Civil EngineeringUniversity of LiverpoolUK

Personalised recommendations