Advertisement

Power Factor Corrected SEPIC and Cuk Converter—A Comparison

  • Alok Kumar Mishra
  • Akshaya Kumar Patra
  • Ramachandra Agrawal
  • Lalit Mohan Satapathy
  • Shekharesh Barik
  • Samarjeet Satapathy
  • Jnana Ranjan Swain
Conference paper
Part of the Lecture Notes in Networks and Systems book series (LNNS, volume 109)

Abstract

This paper presents a comparative analysis between the two converter topologies namely single-ended primary inductance converter (SEPIC) and Cuk converter used for power factor correction. MATLAB/Simulink models of SEPIC and Cuk converter are developed to improve the input power factor and output voltage regulation. Average current control technique is used for input power factor correction and to get a regulated voltage at the output proportional integral (PI) or fuzzy logic controller (FLC) is adopted. The system is tested at both steady state, transient condition and its performance is then estimated and compared in terms of various parameters like total harmonic distortion (THD), input power factor and output voltage ripple for PI and FLC.

Keywords

PI FLC SEPIC Cuk converter Average current control Power factor correction circuits 

References

  1. 1.
    Mishra AK, Pathak MK, Das S (2011) Isolated converter topologies for power factor correction—a comparison. In: IEEE International conference on energy, automation and signal 28 Dec 2011, pp 1–6Google Scholar
  2. 2.
    Kuiyuan W (2006) The comparison and choice of several power factor correction methods. In: IEEE vehicle power and propulsion conference, Sep 2006. IEEE, pp 1–5Google Scholar
  3. 3.
    519–2014 IEEE recommended practice and requirements for harmonic control in electric power systems, 11 June 2014, pp 1–29Google Scholar
  4. 4.
    Pressman I (1991) Switching power supply design. McGraw-Hill, New YorkGoogle Scholar
  5. 5.
    Singh B, Singh BN, Chandra A, Al-Haddad K, Pandey A, Kothari DP (2003) A review of single-phase improved power quality AC-DC converters. IEEE Trans Ind Electron 50(5):962–981CrossRefGoogle Scholar
  6. 6.
    Batarseh I Power electronics circuits, 3rd edn. WileyGoogle Scholar
  7. 7.
    Richard R (1994) The fundamentals of power factor correction. Int. J. Elect. Eng. Educ. 31:213–229CrossRefGoogle Scholar
  8. 8.
    Dah D, Ki SK (2013) Light-load efficiency improvement in buck-derived single-stage single-switch PFC converters. IEEE Trans Power Electron 28(5):2105–2110Google Scholar
  9. 9.
    Liu X, Xu J, Chen Z et al (2015) Single-inductor dual-output buck–boost power factor correction converter. IEEE Trans Ind Electron 62(2):943–952CrossRefGoogle Scholar
  10. 10.
    Kanaan HY, Al-Haddad K, Fnaiech F (2004) Switching-function-based modeling and control of a SEPIC power factor correction circuit operating in continuous and discontinuous current modes. In: IEEE international conference on industrial technology, vol 1, no 8, Dec 2004, pp 431-437Google Scholar
  11. 11.
    Umamaheswari MG, Uma G (2013) Analysis and design of reduced order linear quadratic regulator control for three phase power factor correction using Cuk rectifiers. Electr Power Syst Res 1(96):1–8CrossRefGoogle Scholar
  12. 12.
    Umamaheswari MG, Uma G, Vijitha SR (2012) Comparison of hysteresis control and reduced order linear quadratic regulator control for power factor correction using DC–DC Cuk converters. J Circ Syst Comput 21(1):1250002CrossRefGoogle Scholar
  13. 13.
    Umamaheswari MG, Uma G, Isabella LA (2014) Analysis and design of digital predictive controller for PFC Cuk converter. J Comput Electron 13(1):142–154CrossRefGoogle Scholar
  14. 14.
    Poorali B, Adib E (2016) Analysis of the integrated SEPIC-flyback converter as a single-stage single- switch power-factor-correction LED driver. IEEE Trans Ind Electron 63(6):3562–3569CrossRefGoogle Scholar
  15. 15.
    Melo PF, Gules R, Ribeiro EF et al (2010) A modified SEPIC converter for high-power-factor rectifier and universal input voltage applications. IEEE Trans Power Electron 25(2):310–321CrossRefGoogle Scholar
  16. 16.
    Sudhakarababu C, Veerachary M (2004) Zeta converter for power factor correction and voltage regulation. In: 2004 IEEE region 10 conference TENCON 2004, vol 500. IEEE, pp 61–64Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2020

Authors and Affiliations

  • Alok Kumar Mishra
    • 1
  • Akshaya Kumar Patra
    • 1
  • Ramachandra Agrawal
    • 1
  • Lalit Mohan Satapathy
    • 1
  • Shekharesh Barik
    • 2
  • Samarjeet Satapathy
    • 1
  • Jnana Ranjan Swain
    • 1
  1. 1.EEE DepartmentITER, S‘O’A (Deemed to be University)BhubaneswarIndia
  2. 2.CSE DepartmentDRIEMS (Autonomous)CuttackIndia

Personalised recommendations