Advertisement

InECCE2019 pp 849-858 | Cite as

Utilization of Filter Harmonic Current Based on Shunt HPF Within the Acceptable IEEE-519 Standard

  • Mohamed A. Omran
  • Izzeldin I. MohdEmail author
  • Abu Zaharin Ahmad
  • Mohamad M. Almelian
  • Fahmi Samsuri
  • Muhamad Z. Sujod
  • Walid K. A. Hasan
  • Mohamed Salem
Conference paper
  • 28 Downloads
Part of the Lecture Notes in Electrical Engineering book series (LNEE, volume 632)

Abstract

Harmonic-related problems such as communication noise, malfunctioning of the solid-state control circuit, etc., are often encountered in industrial plants that have a significant amount of rectification. Different techniques to eliminate harmonics current from power systems to the ground have been proposed and one of them is shunt HPF which is an effective and widely-used method for power quality improvement. This paper presents the idea of reusing the HPF harmonic current created based on STF–SRF theory to feed AC load within the limits of IEEE-519 (Less 5%). The circuit has been simulated in the MATLAB-Simulink and tested under distorted source voltage with varying loads. The outcomes of the simulations showed the THD at PCC to be less than 5% even when the HPF current was connected to the system (increasing the source current).

Keywords

Total harmonic distortion (THD) Passive power filter Hybrid power filter Self-tuning filter LMBP controller 

Notes

Acknowledgements

This research is funded by University Malaysia Pahang, UMP Lab2Market Research Fund (UIC170901). This acknowledgment also goes to the Faculty of Electrical and Electronics Engineering for providing us with facilities to conduct this research.

References

  1. 1.
    Tang Y et al (2012) Generalized design of high performance shunt active power filter with output LCL filter. IEEE Trans Ind Electron 59(3):1443–1452Google Scholar
  2. 2.
    Subjak JS, Mcquilkin JS (1990) Harmonics-causes, effects, measurements, and analysis: an update. IEEE Trans Ind Appl 26(6):1034–1042Google Scholar
  3. 3.
    Omran MA et al (2018) Shunt hybrid active power filter based on two compensation strategies with PI and fuzzy logic controllers. J Telecommun Electron Comput Eng (JTEC) 10(1–3):75–79Google Scholar
  4. 4.
    Almelian MM et al (2018) Performance of unified power quality conditioner (UPQC) based on fuzzy controller for attenuating of voltage and current harmonics. In: IOP conference series: materials science and engineering, vol 342, no 1. IOP Publishing, UKGoogle Scholar
  5. 5.
    Mohamed MA (2015) Design of a shunt active power filter to mitigate the harmonics caused by nonlinear loads. Doctoral dissertation, Universiti Tun Hussein Onn MalaysiaGoogle Scholar
  6. 6.
    Zobaa AF (2014) Optimal multiobjective design of hybrid active power filters considering a distorted environment. IEEE Trans Ind Electron 61(1):107–114Google Scholar
  7. 7.
    Soomro DM, Almelian M (2015) Optimal design of a single tuned passive filter to mitigate harmonics in power frequency. ARPN J Eng Appl Sci 10(19):9009–9014Google Scholar
  8. 8.
    Hoon Y et al (2017) Control algorithms of shunt active power filter for harmonics mitigation: a review. Energies 10(12):2038Google Scholar
  9. 9.
    Martinek R et al (2019) Least mean squares and recursive least squares algorithms for total harmonic distortion reduction using shunt active power filter control. Energies 12(8):1545Google Scholar
  10. 10.
    Hoon Y et al (2017) A refined self-tuning filter-based instantaneous power theory algorithm for indirect current controlled three-level inverter-based shunt active power filters under non-sinusoidal source voltage conditions. Energies 10(3):277Google Scholar
  11. 11.
    Al-bayaty H, Ambroze M, Ahmed MZ (2014) Taking advantage of the harmonics at the load side using passive filters. In: The 2014 2nd international conference on systems and informatics (ICSAI 2014). IEEEGoogle Scholar
  12. 12.
    Al-bayaty H, Ambroze M, Ahmed MZ (2016) Feeding loads via harmonics utilization in ac circuit systems. In: 2016 international conference for students on applied engineering (ICSAE). IEEEGoogle Scholar
  13. 13.
    Al-bayaty H, Ambroze M, Ahmed MZ (2015) The benefit of harmonics current using a new topology of hybrid active power filter. In: 2015 IEEE 5th international conference on power engineering, energy and electrical drives (POWERENG). IEEEGoogle Scholar
  14. 14.
    Al-bayaty H, Ambroze M, Ahmed MZ (2016) Utilization of harmonics current in single phase system. In: 2016 17th international conference on harmonics and quality of power (ICHQP). IEEEGoogle Scholar
  15. 15.
    Omran MA et al (2018) Investigating the ability of shunt hybrid power filter based on SRF method under non-ideal supply voltage. In: IOP conference series: materials science and engineering, vol 342, no 1. IOP Publishing, UKGoogle Scholar
  16. 16.
    Montero MIM, Cadaval ER, González FB (2007) Comparison of control strategies for shunt active power filters in three-phase four-wire systems. IEEE Trans Power Electron 22(1):229Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2020

Authors and Affiliations

  • Mohamed A. Omran
    • 1
  • Izzeldin I. Mohd
    • 1
    Email author
  • Abu Zaharin Ahmad
    • 1
  • Mohamad M. Almelian
    • 1
  • Fahmi Samsuri
    • 1
  • Muhamad Z. Sujod
    • 1
  • Walid K. A. Hasan
    • 2
  • Mohamed Salem
    • 3
  1. 1.Faculty of Electrical and Electronics EngineeringUniversiti Malaysia Pahang (UMP)PekanMalaysia
  2. 2.Faculty of Engineering/JaduUniversity of Aljabal AlgharbiGhiryanLibya
  3. 3.School of Electrical and Electronic EngineeringUniversiti Sains Malaysia (USM)Nibong TebalMalaysia

Personalised recommendations