Advertisement

Multi-verse Optimizer for Dynamic Stability Analysis Using STATCOM and Power System Stabilizer

  • P. K. DhalEmail author
Conference paper
  • 17 Downloads
Part of the Advances in Intelligent Systems and Computing book series (AISC, volume 1089)

Abstract

This paper investigates a novel nature-inspired algorithm called as multi-verse optimizer (MVO) used for solving optimization problem in power system 39-bus system. The main objective in this paper is the dynamic stability analysis using static synchronous (STATCOM) and power system stabilizer (PSS). The power system disturbance occurs mainly due to three-phase fault. The voltage profile and system stability are affected. It needs PSS controller to compensate and to improve the stability after the disturbances. The STATCOM location is vital and should be optimized to place certain point in the network for maximum benefit of the system. The different operating conditions are considered: without STATCOM, PSS, with STATCOM, PSS and STATCOM, and PSS tuned by MVO algorithm. It is analyzed by PSAT software. It shows that MVO gives novel optimization values in the systems.

Keywords

Dynamic stability STATCOM Power system stabilizer Multi-verse optimizer 

References

  1. 1.
    Trived, I.N., et al.: Voltage stability enhancement and voltage minimization using multi-verse optimizer algorithm. In: 2016 International Conference on Circuit, Power and Computing Technologies (ICCPCT)Google Scholar
  2. 2.
    Bhavani, T., Lavanya, K., Narasimharao, N.: Enhancement of dynamic stability and voltage control of a grid-connected OWF and MCF using a STATCOM. Int. J. Adv. Eng. Global Technol. 04(01) (2016)Google Scholar
  3. 3.
    Mirjalili, S., Mirjalili, S.M., Hatamlou, A.: Multi-verse optimizer: a nature-inspired algorithm for global optimization. Nat. Comput. Appl. (2015)Google Scholar
  4. 4.
    Siddiqui, A.S., Deb, T.: Voltage stability improvement using STATCOM and SVC. Int. J. Comput. Appl. 88(14) (2014)Google Scholar
  5. 5.
    El-Sinnary, A.-R.I.H., Ibrahim El-Sayed, M., Mostafa, A.-E.-R.E.A.: Dynamic voltage stability of power systems. IJEDR 2(2) (2014)Google Scholar
  6. 6.
    Khalkho, P., Singh, A.K.: Transient stability improvement by using PSS and increasing inertia of synchronous machine. Am. J. Electr. Power Energy Syst. 3(2), 45–49 (2014)Google Scholar
  7. 7.
    Min, R., Xu, F., Yuan, F., Gao, Z.: Coordinated control of multi-FACTS to enhance the dynamic stability of the power system. Energy Power Eng. 5, 1187–1191 (2013)CrossRefGoogle Scholar
  8. 8.
    Falehi, A.D., Rostami, M., Mehrjardi, H.: Transient stability analysis of power system by coordinated PSS-AVR design based on PSO technique. Energy Power Eng. 3, 478–484 (2011)Google Scholar
  9. 9.
    Farahani, S.S.S., Nikzad, M., Tabar, M.B., Yousefpour, B., Tourang, H.: Dynamic stability enhancement of power system using STATCOM. Indian J. Sci. Technol. 4(11) (2011)Google Scholar
  10. 10.
    Dhal, P.K.: Improvement of stability by optimal location with tuning STATCOM using particle swarm optimization algorithm. Adv. Intell. Syst. Comput. 434, 583–593 (2016)Google Scholar
  11. 11.
    Karthikeyan, K., Dhal, P.K.: Transient stability enhancement by optimal location and tuning of STATCOM using PSO’. Procedia Technol. 21, 345–351 (2015)CrossRefGoogle Scholar
  12. 12.
    Karthikeyan, K., Dhal, P.K.: Multiverse optimization (MVO) technique based voltage stability analysis through continuation power flow in IEEE 57 bus. Energy Procedia 117, 583–591 (2017)CrossRefGoogle Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2020

Authors and Affiliations

  1. 1.Department of Electrical and Electronics EngineeringVel Tech Rangarajan Dr. Sagunthala R&D Institute of Science and TechnologyChennaiIndia

Personalised recommendations