Advertisement

Application Design of Virtual Assembly Simulation Technology for Installing Cables on Biaxial Drive Mechanism

  • Chunsheng YangEmail author
  • Yufeng Huang
  • Yi Lu
  • Feng Xue
  • Zhenyue Ren
  • Guoyu Liu
Conference paper
Part of the Lecture Notes in Electrical Engineering book series (LNEE, volume 550)

Abstract

Based on virtual assembly simulation technique for installing cables on biaxial drive mechanism, this paper describes the process of building flexible virtual assembly environment and simulating installation of cables. First of all, the basic element of cable-laying is simulated, such as wires, thermistors, heat plates, etc. Then the process of cable laying is simulated and analyzed by step level in detail. The laying path of each wire is carefully planned in the complex space surface of biaxial drive mechanism. The feasibility of the path is validated in view of overall laying course. The length of each wire can be determined. So it can get the specific process parameters. The project application results indicate that the virtual simulation technique can optimize the process of the spacecraft assembly and integration design, avoid faults by mistake, extend the process expression technique, insure the reliability of irreversible operations, and enhance the level of process design.

Keywords

Virtual assembly simulation Biaxial drive mechanism Assembly process design 

References

  1. 1.
    Yang, Z., Li, L., et al.: 3D digital assembly process for rocket body cabin. Aerosp. Mater. Technol. 4, 85–91 (2016)Google Scholar
  2. 2.
    Yuan, C.: Assembly process simulation of rocket components and on-site visualization technology application. Xi’an University of Electronic Science and Technology (2015)Google Scholar
  3. 3.
    Feng, W., Zhang, Y., et al.: The virtual simulation technology in assembly process design of china’s lunar exploration project II. Spacecraft Environ. Eng. 6, 326–331 (2014)Google Scholar
  4. 4.
    Zhou, R., Zhang, H., et al.: Virtual assembly process simulation of Bogie based on DELMIA. Mach. Electron. 2, 47–50 (2015)Google Scholar
  5. 5.
    Shen, Z., Zheng, H., et al.: Application of digital assembly simulation technology for complicated vehicle based on DELMIA. Missile Space Launch Technol. 6, 42–45 (2015)Google Scholar
  6. 6.
    Ritchie, J.M., Dewar, R.G., Simmons, J.E.L.: The generation and practical use of plans for manual assembly using immersive virtual reality. In: Proceedings of the Institution of Mechanical Engineers (Part B), vol. 213, pp. 461–474 (1999)CrossRefGoogle Scholar
  7. 7.
    Li, T., Han, F., et al.: Virtual assembly simulation of catheter based on DELMIA. Mech. Manuf. 5, 74–77 (2014)Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2019

Authors and Affiliations

  • Chunsheng Yang
    • 1
    Email author
  • Yufeng Huang
    • 2
  • Yi Lu
    • 1
  • Feng Xue
    • 1
  • Zhenyue Ren
    • 1
  • Guoyu Liu
    • 1
  1. 1.Beijing Institute of Spacecraft Environment EngineeringBeijingChina
  2. 2.Institute of Telecommunication SatelliteBeijingChina

Personalised recommendations