Advertisement

Characterization of Low Noise Amplifier (LNA) for mm-Wave Wireless Systems

  • Mohd Fadzil bin AinEmail author
  • Mohamad Faiz bin Mohamed Omar
  • Roslina bt. Hussin
  • Zainal Arifin bin Ahmad
  • Intan Sorfina Zainal Abidin
  • Mohd Zaid bin Abdullah
Conference paper
Part of the Lecture Notes in Electrical Engineering book series (LNEE, volume 547)

Abstract

This paper reports the technical design of millimeter wave (mm-Wave) low noise amplifier (LNA). The fast-growing wireless communication market and the necessity of a higher data rate certainly drive the radio frequency (RF) system towards the mm-Wave technology. The 28 GHz channel band possesses a large amount of raw bandwidth space with a spectrum allocation that exceeds the bandwidth of 1 GHz. The mm-Wave cellular wireless system is developed to address with a worldwide wireless bandwidth shortage. The 28 GHz LNA is used to amplify a very low signal at 28 GHz and minimize the present of unwanted additional noises. The performances of single and cascaded LNAs are analyzed and presented. The footprint design of LNA is fabricated on ROGERS 4003 C with permittivity of 3.38. The off-the-shelf commercial MMIC LNA is mounted and matched to 50 Ω. The fabricated LNA is analyzed based on the output power levels and signal gains. The minimum and maximum gains for a single LNA are recorded at 11 dB and 14.83 dB respectively. 22.05 dB is verified as the lowest gain for the cascaded LNA while the highest gain is indicated at 28.83 dB when the RF signal input power is quoted at −74.54 dBm.

Keywords

Low noise amplifier (LNA) Monolithic microwave integrated circuit (MMIC) Millimeter wave (mm-Wave) Surface mount technology 

Notes

Acknowledgements

This project is sponsored under USM grant scheme titled High Gain Antenna For Long Range Microwave Radio under project no. 304.PELECT.6316101.

References

  1. 1.
    Nieuwoudt, A., Ragheb, T., Massoud, Y.: SOC-NLNA: Synthesis and Optimization for Fully Integrated Narrow-Band CMOS Low Noise Amplifiers (1-59593-381-6/06/0007), Houston, TexasGoogle Scholar
  2. 2.
    Subramanian, V., Spiegel, S.: A CMOS low noise amplifier for 5–6 GHz wireless applications. In 2007 SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference, pp. 778–781 (2007)Google Scholar
  3. 3.
    Degroat, J., Roblin, P., Klein, C.: A CMOS Front End for High Linearity Zero-IF WCDMA Receiver. Ohio State University, PHD (2006)Google Scholar
  4. 4.
    Kalivas, G.A.: Design a power amplifier for IEEE 802.16a STANDARD. Diploma. University of Patras (2013)Google Scholar
  5. 5.
    Bursky, D.: Low-noise amplifiers maximize receiver sensitivity. In: Article Library. Electronic Products pp. 1–2 (2012)Google Scholar
  6. 6.
    Salmeh, R., Maundy, B., Johnston, R.: A novel wide-band 5.3 GHz ESD protected input and output matched low noise amplifier. In: 50th Midwest Symposium Circuits and Systems, 2007. MWSCAS 2007, pp. 996–999 (2007)Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2019

Authors and Affiliations

  • Mohd Fadzil bin Ain
    • 1
    Email author
  • Mohamad Faiz bin Mohamed Omar
    • 1
  • Roslina bt. Hussin
    • 1
  • Zainal Arifin bin Ahmad
    • 2
  • Intan Sorfina Zainal Abidin
    • 1
  • Mohd Zaid bin Abdullah
    • 1
  1. 1.School of Electrical and Electronic EngineeringUniversiti Sains Malaysia, Engineering CampusNibong TebalMalaysia
  2. 2.School of Materials and Mineral Resources EngineeringUniversiti Sains Malaysia, Engineering CampusNibong TebalMalaysia

Personalised recommendations