Relationship of Oil Composition and Lubricating Characteristics in Cold Rolling Aluminum Strips

  • Yongtao Zhao
  • Jianlin Sun
  • Guangzhao Yuan
  • Chenglong Wang
Conference paper
Part of the Lecture Notes in Mechanical Engineering book series (LNME)

Abstract

To explore the relationship of oil composition and lubricating characteristics, new base oils with different carbon chain length and aromatics contents for lubrication in cold rolling aluminum process were investigated by means of Gas Chromatography-Mass Spectrometry. Tribological tests were carried out on a four-ball friction and wear testing machine. Results showed that the film strength gradually increased with an increasing of aromatics content in oils and friction coefficients decreases simultaneously. Cold rolling experiments were conducted to be further to analyze the lubrication effects of new rolling oils by a 4-high mill. The curves of lubricating characteristics in rolling were obtained, and the minimum rolling thickness after rolling under different lubricating conditions was found to decrease obviously.

Keywords

Rolling oil Composition Lubrication characteristics 

References

  1. 1.
    X. Fu, W. Yao, L. Zhang, The current status and development trend of additives in lubricating oils. Automobile Technol. Mater. 5, 1–6 (2005)Google Scholar
  2. 2.
    W. Du, G. Li, Oil residual on foil surface with wider width high speed aluminum foil mill and improving methods. Light Alloy Process. Technol. 35(6), 34–35 (2007)Google Scholar
  3. 3.
    C.N. Panagopoulos, E.P. Georgiou, Cold rolling and lubricated wear of 5083 aluminum alloy. Mater. Des. 31, 1050–1055 (2010)CrossRefGoogle Scholar
  4. 4.
    J. Sun, Y. Sun, M.A. Yanli et al., Effect of rolling oil on the surface quality of annealed aluminum foils. J. Univ. Sci. Technol. B 30(2), 137–140 (2008)Google Scholar
  5. 5.
    J. Shibata, T. Wakabayashi, S. Mori, Adsorption characteristics and lubricating performance of coolant components in cold rolling of aluminum. Tribol. Int. 40(5), 748–753 (2007)CrossRefGoogle Scholar
  6. 6.
    J. Sun, Y. Kang, T. Xiao, J. Wang, Lubrication in strip cold rolling process. J. Univ. Sci. Technol. B 11(4), 368–372 (2004)Google Scholar
  7. 7.
    J. Sun, Y. Huang, M. Lu, Optimize aluminum’s surface roughness in rolling lubrication process. Ind. Lubr. Tribol. 65(3), 175–180 (2013)CrossRefGoogle Scholar
  8. 8.
    Z. Liao, S. Yang, Analysis and discussion on effect factors of aluminum foil rolling process. Nonferrous Met. Process. 43(1), 21–24 (2014)Google Scholar

Copyright information

© Springer Nature Singapore Pte Ltd. 2018

Authors and Affiliations

  • Yongtao Zhao
    • 1
    • 2
  • Jianlin Sun
    • 1
  • Guangzhao Yuan
    • 1
  • Chenglong Wang
    • 1
  1. 1.School of Materials Science and EngineeringUniversity of Science and Technology BeijingBeijingChina
  2. 2.School of Mechanical EngineeringHenan University of EngineeringZhengzhouChina

Personalised recommendations