Formation Sampling and Sand Analysis

  • Davorin Matanović
  • Marin Čikeš
  • Bojan Moslavac
Chapter
Part of the Springer Environmental Science and Engineering book series (SPRINGERENVIRON)

Abstract

The starting point for any kind of sand control with respect to geomechanical approach is proper sampling and sand screen analysis. Use of bailed or produced sand samples leads to mistakes and problems and is the poorest kind of data that can be used in designing sand control. The representative samples are obtained by coring the whole length of the interval with adequate coring equipment. Particle size distribution is then determined through sieve and laser particle size (LPS) analysis.

LPS is used to determine the amount of fine particles that exist due the swelling and migration of bonding clays, or due the crushing during production.

Such analysis is the basis for proper design of liner openings, screens or gravel pack sizing.

Keywords

Sieve Analysis Laser Particle Size Analysis Relaxation Time Distribution Produce Sand Sand Control 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Notes

Nomenclature

Phi

From Eq. 2.1

d

Grain diameter, mm

References

  1. API Recommended Practice 58 (1995) Recommended Practice for Testing Sand Used in Gravel Packing Operations American Petroleum Institute, Washington, DCGoogle Scholar
  2. Baker handbook – instrumentation Borivoje, Recommended Practice for Testing Sand Used in Gravel Packing OperationsGoogle Scholar
  3. Baker Hughes Inteq (1999) Coring Handbook, 503-001 Rev.c, Houston, November 1999Google Scholar
  4. Buzarde LE Jr, Karl RL, Bell WT, De Priester CL (1982) Lecture notes for: Production operations course 1: Well completions. In: SPE of AIME, DallasGoogle Scholar
  5. Chen J, Chen S, Altunbay MM, Tyurin E (2010) A new method of grain size determination for sand-control completion application, SPE 128011. In: International symposium and exhibition on formation damage control, Lafayette, 10–12 Feb 2010Google Scholar
  6. Dowel Schlumberger (1979) The Complete Sand Control Package; Gravel Pack Guide 2, A Design Manual for Gravel Pack Completions. Dowel Schlumberger, Services, Products & Technology, Technical Department, January 1979Google Scholar
  7. Maly GP, Krueger RF (1971) Improper formation sampling leads to improper selection of gravel size. J Pet Technol, December 1971, Vol. 23, No. 12, 1403–1408Google Scholar
  8. Slayter AG, Byrne M, McPhee CA, McCurdy P (2008) Sand management: what are we sure of? SPE 1147781. In: SPE Asia Pacific oil & gas conference and exhibition, Perth, 20–22 Oct 2008Google Scholar
  9. Underdown DR, Newhouse DP, Fisher CB (1986) On-site completion/workover fluid analysis using a portable laser particle size counter, SPE 15407. In: 61st technical conference and exhibition of the SPE, New Orleans, 5–8 Oct 1986Google Scholar

Copyright information

© Springer-Verlag Berlin Heidelberg 2012

Authors and Affiliations

  • Davorin Matanović
    • 1
  • Marin Čikeš
    • 1
  • Bojan Moslavac
    • 1
  1. 1.Faculty of Mining, Geology and Petroleum Engineering Petroleum Engineering DepartmentUniversity of ZagrebZagrebCroatia

Personalised recommendations