Advertisement

A Case Study of Roadway Embankment Construction Over Existing Sewers in Montreal, Canada

  • Laifa Cao
  • Scott Peaker
Conference paper
Part of the Sustainable Civil Infrastructures book series (SUCI)

Abstract

This paper presents a case study of the influence of a roadway embankment on existing sewers with diameter or width of approximately 3.3 to 4.3 m. The proposed embankment would be constructed directly above the existing sewers, which would induce an additional load. Traditional analysis methods cannot account for the structural/soil interaction and the benefit of the lateral supporting characteristics of the soils. In order to evaluate the loading of the proposed embankment on the existing sewers, a structural/soil interaction analysis using a two-dimensional finite element computer program was performed for various loading cases. The sensitivity of soil parameters was also considered in the analysis. From the analysis, the loadings on the sewers including axial force, bending moment and shear force were obtained and then the structural capacity of the existing sewers was checked. Light-weight sand fill or expanded polystyrene (EPS) geofoam was considered to reduce the additional vertical and horizontal loads on the sewers. The EPS geofoam or a structural protection system consisting of a concrete slab supported by concrete piles was considered to eliminate any incremental vertical and horizontal loads on the sewers. These mitigation methods were compared. It is found that the light-weight sand fill is most economic material to reduce the additional loads on the sewers, the EPS geofoam is most suitable material to eliminate incremental loads on the sewers for a lower embankment, and the structural protection system is only option to eliminate incremental loads on the sewers for a higher embankment.

References

  1. ASCE/ANSI: Standard Practice for Direct Design of Buried Precast Concrete Standard Installation (SIDD). ANSI/ASCE 15–93. American Society of Civil Engineers/American National Standards Institute (1993)Google Scholar
  2. ACPA: Concrete Pipe Handbook. American Concrete Pipe Association, Irving, Texas, US (1998)Google Scholar
  3. CSA: Canadian Highway Bridge Design Code, CAN/CSA S6-06. Canadian Standards Association, CSA International, Toronto (2006)Google Scholar
  4. CSA: Commentary on CSA S6-14, Canadian Highway Bridge Design Code, CAN/CSA S6.1-14. Canadian Standards Association, CSA International, Toronto (2014)Google Scholar
  5. Spangler, M.G., Handy, R.L.: Soil Engineering, 4th edn. Harper & Row, New York (1982)Google Scholar
  6. Smeltzer. P.D., Daigle, L.: Field performance of a concrete pipe culvert installed using standard installations. In: 33rd Annual general conference of the canadian society for civil engineering. Toronto, Canada (2005)Google Scholar
  7. The EPS Industry Alliance: Expanded Polystyrene (EPS) Geofoam Applications & Technical Data, Crofton, MD (2012)Google Scholar
  8. Transportation Research Board: Guideline and Recommended Standard for Geofoam Applications in Highway Embankments, NCHRP Report 529, Washington, D.C (2004)Google Scholar
  9. Valestad, J., Sayd, M.S., Johansen, T.H., Wiman, L.: Load reduction and arching on buried rigid culverts using EPS Geofoam. Design methods and instrumented field tests. In: 4th International Conference on the Use of Geofoam Blocks in Construction Applications, Norway (2011)Google Scholar

Copyright information

© Springer International Publishing AG, part of Springer Nature 2019

Authors and Affiliations

  1. 1.Geotechnical EngineerWSP Canada IncTorontoCanada
  2. 2.GeotechnicsWSP Canada IncTorontoCanada

Personalised recommendations