Advertisement

Microturbine with Heat Exchanger with Regeneration Ratio Equal 95%

  • A. V. Kostukov
  • L. A. Kosach
  • A. S. Gornovskii
Conference paper
Part of the Lecture Notes in Mechanical Engineering book series (LNME)

Abstract

Using microturbines, which have very small emissions, seems to be very promising for Russia where using “green” energy is ineffective in most parts of its vast territory. There are significant opportunities for using microturbines in vehicles. Ordinary microturbines have smaller efficiency and therefore bigger fuel consumption than piston internal combustion engines. The increase in the efficiency of microturbines to the level of piston engines and higher can be obtained by using a heat exchanger with the high regeneration ratio (95–97%) and acceptable sizes. In this paper, the construction of such heat exchanger is presented. In addition, the results of the simulations are provided that show that using ceramics for making the heat exchanger’s disc makes it possible to significantly reduce deformation of the disc and therefore reduce air leakage. Other results of microturbine design are presented (the results of the thermodynamic calculations of the engine’s working cycle, the results of flow simulation in the compressor and turbine stages, and the results of flow and combustion simulation in combustion chamber). It is shown that a microturbine’s efficiency can reach 38% and there are possibilities to increase it further.

Keywords

Microturbine Heat exchanger Combustion chamber Low emission 

References

  1. 1.
    Plotnikov DA (1981) Development and research of disc sectional regenerators of automotive GTE. DissertationGoogle Scholar
  2. 2.
    Dementiev AA, Kostukov AV (2013) Cooling of the frame of a rotary heat exchanger. Izvest MGTU MAMI 1(15) PatentGoogle Scholar
  3. 3.
    Kostukov AV, Krutov MA et al (2007) The method of cooling the frame of the rotating disc heat exchanger and the device for its implementation. RU patent 2296930, 10.04.2007Google Scholar
  4. 4.
    Sysoev AP, Shevyakov AO, Kosach LA, Gornovskii AS (2016) Design and flow simulation in a radial-axial turbine using modern simulation and design complexes. In: Scholarly discussion: problems of technical sciences, proceedings of XLVII international scientific-practical conference 6(36)Google Scholar
  5. 5.
    Benini E (2013) Progress in gas turbine performance. In: InTech, 2013Google Scholar
  6. 6.
    Gornovskii AS, Valeev AG (2015) Computational analysis of methane’s burning. Naukograd 3(5)Google Scholar
  7. 7.
    Kostukov AV, Kosach LA (2015) Changes of a heat exchanger`s efficiency caused by changing the gas-turbine engine load. Naukograd 3(5)Google Scholar
  8. 8.
    Kostukov AV, Dementiev AA (2011) High temperature rotary heat exchanger for gas turbine and gerotor engines. Izvest MGTU MAMI 2Google Scholar

Copyright information

© Springer Nature Switzerland AG 2019

Authors and Affiliations

  • A. V. Kostukov
    • 1
  • L. A. Kosach
    • 1
  • A. S. Gornovskii
    • 1
  1. 1.Moscow Polytechnic UniversityMoscowRussia

Personalised recommendations