Advertisement

Hybrid RANS-LES Simulation of a Tall Building in a Complex Urban Area

  • Joshua MillarEmail author
  • Rhys Wayland
  • Joshua Holgate
Conference paper
Part of the Notes on Numerical Fluid Mechanics and Multidisciplinary Design book series (NNFM, volume 143)

Abstract

The aerodynamic performance of a building becomes increasingly important as its height protrudes further into the atmospheric boundary layer. For tall buildings, a thorough understanding of the aerodynamics is essential to make informed structural design decisions. However, this is a challenging case for numerical simulation as it involves accurate representation of both the bluff body aerodynamics and the incoming turbulent flow field over a large range of scales. Hybrid RANS-LES methods provide an attractive option for practical cases due to lower mesh requirements close to the wall of complex geometries. In this study, Detached Eddy Simulation has been used to simulate the flow around both an isolated standardised building as well as a tall building in a complex urban environment. Results show a good comparison to wind tunnel data, suggesting that the method could be a valuable tool in the design of tall buildings under wind loading.

References

  1. 1.
    Cheng, H., Robins, A.: Wind tunnel simulation of field tracer release in london. In: Proceedings of Fourth International Conference on Fluid Mechanics (2004)Google Scholar
  2. 2.
    Dagnew, A., Bitsuamlak, G.T.: Computational evaluation of wind loads on buildings: a review. Wind Struct. 16(6), 629–660 (2013)CrossRefGoogle Scholar
  3. 3.
    ESDU: Computer program for wind speeds and turbulence properties: flat or hilly sites in terrain with roughness changes. Rev. C 11 (2010)Google Scholar
  4. 4.
    Harris, R.: Some further thoughts on the spectrum of gustiness in strong winds. J. Wind Eng. Indu. Aerodyn. 33(3), 461–477 (1990)CrossRefGoogle Scholar
  5. 5.
    Holmes, J.D., Tse, T.K.: International high-frequency base balance benchmark study. Wind Struct. 18(4), 457–471 (2014)CrossRefGoogle Scholar
  6. 6.
    Jarrin, N., Prosser, R., Uribe, J.-C., Benhamadouche, S., Laurence, D.: Reconstruction of turbulent fluctuations for hybrid rans/les simulations using a synthetic-eddy method. Int. J. Heat Fluid Flow 30(3), 435–442 (2009)CrossRefGoogle Scholar
  7. 7.
    Kim, J., Moin, P., Moser, R.: Turbulence statistics in fully developed channel flow at low reynolds number. J. Fluid Mech. 177, 133–166 (1987)CrossRefGoogle Scholar
  8. 8.
    Obasaju, E.: Measurement of forces and base overturning moments on the CAARC tall building model in a simulated atmospheric boundary layer. J. Wind Eng. Ind. Aerodyn. 40(2), 103–126 (1992)CrossRefGoogle Scholar
  9. 9.
    Poletto, R., Craft, T., Revell, A.: A new divergence free synthetic eddy method for the reproduction of inlet flow conditions for les. Flow Turbul. Combust. 91(3), 519–539 (2013)CrossRefGoogle Scholar
  10. 10.
    Spalart, P., Allmaras, S.: A one-equation turbulence model for aerodynamic flows. In: 30th Aerospace Sciences Meeting and Exhibit, p. 439 (1992)Google Scholar
  11. 11.
    Spalart, P.R.: Comments on the feasibility of les for wings, and on hybrid rans/les approach., vol. 1997 (1997)Google Scholar
  12. 12.
    Tabor, G.R., Baba-Ahmadi, M.: Inlet conditions for large eddy simulation: a review. Comput. Fluids 39(4), 553–567 (2010)MathSciNetCrossRefGoogle Scholar
  13. 13.
    Tamura, T., Nozawa, K., Kondo, K.: Aij guide for numerical prediction of wind loads on buildings. J. Wind Eng. Ind. Aerodyn. 96(10–11), 1974–1984 (2008)CrossRefGoogle Scholar
  14. 14.
    Tschanz, T., Davenport, A.G.: The base balance technique for the determination of dynamic wind loads. In: Wind Engineering 1983, Part 3A, pp. 429–439. Elsevier, Amsterdam (1984)Google Scholar

Copyright information

© Springer Nature Switzerland AG 2020

Authors and Affiliations

  1. 1.WSPLondonUK

Personalised recommendations