Advertisement

Literature Survey

  • Adel A. Elbaset
  • Saad Awad Mohamed Abdelwahab
  • Hamed Anwer Ibrahim
  • Mohammed Abdelmowgoud Elsayed Eid
Chapter

Abstract

A fundamental characteristic of a PV system is that power is produced only when sunlight is available. For systems in which the PV is the only generation source, storage is typically needed since an exact match between available sunlight and the load is limited to a few types of systems – for example, powering a cooling fan. In hybrid or grid-connected systems, where batteries energy storage (BESs) are not inherently required, they may be beneficially included for load matching or power conditioning. By far the most common type of storage is chemical storage, in the form of a battery energy storage (BES), although in some cases other forms of storage can be used [24]. For example, for small, short-term storage, a flywheel or capacitor can be used for storage, or for specific, single-purpose PV systems, such as water pumping or refrigeration, storage can be in the form of water or ice.

References

  1. 24.
    O. Hazem Mohammed, Y. Amirat, M. Benbouzid, G. Feld, T. Tang, A.A. Elbaset, Optimal design of a stand-alone hybrid PV/fuel cell power system for the city of Brest in France. Int. J. Energy Convers. 2(1), 1–7 (2014)Google Scholar
  2. 25.
    S. Pati, S.K. Kar, K.B. Mohanty, D. Panda, Voltage and frequency stabilization of a micro hydro –PV based hybrid micro grid using STATCOM equipped with battery energy storage system. IEEE Int. Conf. Power Electron. Drives Energy Syst. PEDES 2016. 2016(January), 1–5 (2017)Google Scholar
  3. 26.
    A. McEvoy, T. Markvart, L. Castaner, Chapter IIB-2 – Batteries in PV systems, in Practical Handbook of Photovoltaics: Fundamentals and Applications, (Academic Press, Amsterdam/Boston, 2012)Google Scholar
  4. 14.
    S. Sumathi, L. Ashok Kumar, P. Surekha, Solar PV and Wind Energy Conversion Systems (Springer, Cham, 2015)CrossRefGoogle Scholar
  5. 21.
    D. Photovoltaics, Draft Guide for Test and Evaluation of Lead-Acid Batteries Used in Photovoltaic (PV) Hybrid Power Systems, 2006Google Scholar
  6. 27.
    U. Sangpanich, A novel method of decentralized battery energy management for stand-alone PV-battery systems, in Power and Energy Engineering Conference (APPEEC), 2014 IEEE PES Asia-Pacific, 2014, pp. 1–5Google Scholar
  7. 28.
    B.P. Roberts, Sodium-Sulfur (NaS) batteries for utility energy storage applications, in Power and Energy Society General Meeting-Conversion and Delivery of Electrical Energy in the 21st Century, 2008 IEEE, 2008, pp. 1–2Google Scholar
  8. 29.
    G.J. May, A. Davidson, B. Monahov, Lead batteries for utility energy storage: A review. J. Energy Storage 15, 145–157 (2018)CrossRefGoogle Scholar
  9. 30.
    H. Ibrahim, A. Ilinca, J. Perron, Energy storage systems-characteristics and comparisons. Renew. Sust. Energ. Rev. 12(5), 1221–1250 (2008)CrossRefGoogle Scholar
  10. 31.
    The Photovoltaic Education Network, Operation of Lead Acid Batteries | PVEducation. [Online]. Available: https://www.pveducation.org/pvcdrom/lead-acid-batteries/operation-of-lead-acid-batteries. Accessed Jan 03 2019
  11. 32.
    T.B. Issa, P. Singh, M.V. Baker, T. Lee, Potentiometric measurement of state-of-charge of lead-acid batteries using polymeric ferrocene and quinones derivatives. J. Analytical Sci. Methods Instrum. 4(December), 110–118 (2014)Google Scholar
  12. 33.
    D. Berndt, Maintenance-Free Batteries: Lead-Acid, Nickel-Cadmium, Nickel-Hydride... (Research Studies Press, Taunton, 1994)Google Scholar
  13. 34.
    J. Weniger, T. Tjaden, V. Quaschning, Sizing of residential PV battery systems. Energy Procedia 46, 78–87 (2014)CrossRefGoogle Scholar
  14. 35.
    NA, How to Design Solar PV System – Guide for sizing your solar photovoltaic system, Leonics Co., Ltd., 2013. [Online]. Available: http://www.leonics.com/support/article2_12j/articles2_12j_en.php. Accessed Jan 04 2019
  15. 36.
    F. Rafik, H. Gualous, R. Gallay, A. Crausaz, A. Berthon, Frequency, thermal and voltage supercapacitor characterization and modeling. J. Power Sources 165(2), 928–934 (2007)CrossRefGoogle Scholar
  16. 40.
    J.K. Maherchandani, C. Agarwal, M. Sahi, Estimation of solar cell model parameter by hybrid genetic algorithm using Matlab. Int. J. Adv. Res. Comput. Eng. Technol. 1(6), 78 (2012)Google Scholar
  17. 37.
    H. Gualous, D. Bouquain, A. Berthon, J.M. Kauffmann, Experimental study of supercapacitor serial resistance and capacitance variations with temperature. J. Power Sources 123(1), 86–93 (2003)CrossRefGoogle Scholar
  18. 38.
    A. Sumper, F. Díaz-González, O. Gomis-Bellmunt, Energy Storage in Power Systems (Wiley, New Delhi, 2016)Google Scholar
  19. 39.
    K. Ishaque, Z. Salam, H. Taheri, Simple, fast and accurate two-diode model for photovoltaic modules. Sol. Energy Mater. Sol. Cells 95(2), 586–594 (2011)CrossRefGoogle Scholar
  20. 41.
    Z. Ahmad, S.N. Singh, Extraction of the internal parameters of solar photovoltaic module by developing Matlab/Simulink based model. Int. J. Appl. Eng. Res. 7, 1 (2012)Google Scholar
  21. 42.
    S. Lineykin, M. Averbukh, A. Kuperman, Issues in modeling amorphous silicon photovoltaic modules by single-diode equivalent circuit. IEEE Trans. Ind. Electron. 61(12), 6785–6793 (2014)CrossRefGoogle Scholar
  22. 43.
    B.C. Babu, S. Gurjar, A novel simplified two-diode model of photovoltaic (PV) module. IEEE J. Photovoltaics 4(4), 1156–1161 (2014)CrossRefGoogle Scholar
  23. 44.
    N.D. Kaushika, N.K. Gautam, Energy yield simulations of interconnected solar PV arrays. IEEE Trans. Energy Convers. 18(1), 127–134 (2003)CrossRefGoogle Scholar
  24. 45.
    W. Xiao, W.G. Dunford, A modified adaptive hill climbing MPPT method for photovoltaic power systems, in Power Electronics Specialists Conference, 2004. PESC 04. 2004 IEEE 35th Annual, 2004, vol. 3, pp. 1957–1963Google Scholar
  25. 48.
    G.-C. Hsieh, H.-I. Hsieh, C.-Y. Tsai, C.-H. Wang, Photovoltaic power-increment-aided incremental-conductance MPPT with two-phased tracking. IEEE Trans. Power Electron. 28(6), 2895–2911 (2013)CrossRefGoogle Scholar
  26. 49.
    S. Mekhilef, K.S. Tey, S. Mekhilef, S. Member, Modified incremental conductance algorithm for photovoltaic system under partial shading conditions and load variation modified incremental conductance algorithm for photovoltaic system under partial shading conditions and load variation. IEEE Trans. Ind. Electron. 61(10), 5384–5392 (2014)CrossRefGoogle Scholar
  27. 50.
    Q. Mei, M. Shan, L. Liu, J.M. Guerrero, A novel improved variable step-size incremental-resistance MPPT method for PV systems. IEEE Trans. Ind. Electron. 58(6), 2427–2434 (2011)CrossRefGoogle Scholar
  28. 51.
    T. Esram, J.W. Kimball, P.T. Krein, P.L. Chapman, P. Midya, Dynamic maximum power point tracking of photovoltaic arrays using ripple correlation control. IEEE Trans. Power Electron. 21(5), 1282–1290 (2006)CrossRefGoogle Scholar
  29. 52.
    A. Al Nabulsi, R. Dhaouadi, Efficiency optimization of a DSP-based standalone PV system using fuzzy logic and dual-MPPT control. IEEE Trans. Ind. Inf. 8(3), 573–584 (2012)CrossRefGoogle Scholar
  30. 53.
    E. Karatepe, T. Hiyama, Artificial neural network-polar coordinated fuzzy controller based maximum power point tracking control under partially shaded conditions. IET Renew. Power Gener. 3(2), 239–253 (2009)CrossRefGoogle Scholar
  31. 54.
    H. Renaudineau et al., A PSO-based global MPPT technique for distributed PV power generation. IEEE Trans. Ind. Electron. 62(2), 1047–1058 (2015)CrossRefGoogle Scholar
  32. 55.
    E. Bianconi et al., A fast current-based MPPT technique employing sliding mode control. IEEE Trans. Ind. Electron. 60(3), 1168–1178 (2013)CrossRefGoogle Scholar
  33. 56.
    F. Paz, M. Ordonez, Zero oscillation and irradiance slope tracking for photovoltaic MPPT. IEEE Trans. Ind. Electron. 61(11), 6138–6147 (2014)CrossRefGoogle Scholar
  34. 57.
    M. Killi, S. Samanta, Modified perturb and observe MPPT algorithm for drift avoidance in photovoltaic systems. IEEE Trans. Ind. Electron. 62(9), 5549–5559 (2015)CrossRefGoogle Scholar
  35. 58.
    R.M. Schupbach, J.C. Balda, Comparing DC-DC converters for power management in hybrid electric vehicles. IEMDC 2003 – IEEE Int. Electr. Mach. Drives Conf. 3(C), 1369–1374 (2003)Google Scholar
  36. 59.
    F.A. Himmelstoss, M.E. Ecker, Analyses of a bidirectional DC-DC half-bridge converter with zero voltage switching, in Signals, Circuits and Systems, 2005. ISSCS 2005. International Symposium on, 2005, vol. 2, pp. 449–452Google Scholar
  37. 60.
    J. Cao, A. Emadi, A new battery/ultracapacitor hybrid energy storage system for electric, hybrid, and plug-in hybrid electric vehicles. IEEE Trans. Power Electron. 27(1), 122–132 (2012)CrossRefGoogle Scholar
  38. 61.
    W.L. Jing, C.H. Lai, W.S.H. Wong, D.M.L. Wong, Smart hybrid energy storage for stand-alone PV microgrid: Optimization of battery lifespan through dynamic power allocation. Appl. Mech. Mater. 833, 19–26 (2016)CrossRefGoogle Scholar
  39. 62.
    I. Shchur, Y. Biletskyi, Interconnection and damping assignment passivity-based control of semi-active and active battery/supercapacitor hybrid energy storage systems for stand-alone photovoltaic installations, in Advanced Trends in Radioelecrtronics, Telecommunications and Computer Engineering (TCSET), 2018 14th International Conference on, 2018, pp. 324–329Google Scholar
  40. 63.
    L.W. Chong, Y.W. Wong, R.K. Rajkumar, D. Isa, Modelling and simulation of standalone PV systems with battery-supercapacitor hybrid energy storage system for a rural household. Energy Procedia 107(September 2016), 232–236 (2017)CrossRefGoogle Scholar

Copyright information

© Springer Nature Switzerland AG 2019

Authors and Affiliations

  • Adel A. Elbaset
    • 1
  • Saad Awad Mohamed Abdelwahab
    • 2
  • Hamed Anwer Ibrahim
    • 2
  • Mohammed Abdelmowgoud Elsayed Eid
    • 2
  1. 1.Minia UniversityEl-Minia Egypt
  2. 2.Suez UniversitySuezEgypt

Personalised recommendations