Advertisement

Turbo Coded STBC MIMO OFDM with DWT Based I/Q Balancing System

  • K. Sundar SrinivasEmail author
  • M. N. L. KalyaniEmail author
  • N. MounikaEmail author
  • Ch. Aruna KumariEmail author
Conference paper
Part of the Advances in Intelligent Systems and Computing book series (AISC, volume 940)

Abstract

The technology MIMO-OFDM (multiple input-multiple output is used for developing various wireless communications. The merging of MIMO and OFDM gives improvement in Bit error rate, capacity and reliability. To achieve high throughput, MIMO is used. The MIMO-OFDM technology in wireless helps to use maximum bandwidth with less cost. Space time block coding (STBC) along with MIMO gives improvement in Bit Error Rate. The performances of the various systems are evaluated by comparing the BER and SNR. In this paper, by using more desirable channel coding technique low Bit error rate is achieved which gives good performance. To improve the efficiency, Orthogonal Frequency Division Multiplexing (OFDM) is integrated into MIMO for digital modulation. DWT based MIMO-OFDM with turbo decoding overcomes the drawbacks in FFT based method like low data transmission and hard decision decoding systems.

Keywords

MIMO-OFDM DWT Bit error rate Signal to Noise Ratio 

References

  1. 1.
    Zhang, J., Chen, S., Mu, X., Hanzo, L.: Turbo multi-user detection for OFDM/SDMA systems relying on differential evolution aided iterative channel estimation. IEEE Trans. Commun. 60(6), 1621–1633 (2012)CrossRefGoogle Scholar
  2. 2.
    Zhang, J., Chen, S., Mu, X., Hanzo, L.: Evolutionary-algorithm-assisted joint channel estimation and turbo multiuser detection/decoding for OFDM/SDMA. IEEE Trans. Vehic. Tech. 63(3), 1204–1222 (2014)CrossRefGoogle Scholar
  3. 3.
    Ahmed, S., Kim, S.Y.: Efficient soft bit estimation for joint iterative multiple-input multiple-output detection. IET Commun. 9(17), 2107–2113 (2015)CrossRefGoogle Scholar
  4. 4.
    Lee, H., Lee, B., Lee, I.: Iterative detection and decoding with an improved V-BLAST for MIMO-OFDM systems. IEEE J. Sel. Areas Commun. 24(3), 504–513 (2006)CrossRefGoogle Scholar
  5. 5.
    Lu, B., Wang, X.: Iterative receivers for multiuser space-time coding systems. IEEE J. Sel. Areas Commun. 18(11), 2322–2335 (2000)CrossRefGoogle Scholar
  6. 6.
    Sandell, M., Luschi, C., Strauch, P., Yan, R.: Iterative channel estimation using soft decision feedback. In: IEEE Global Telecommunications Conference, vol. 6, Sydney, NSW, pp. 3728–3733 (1998)Google Scholar
  7. 7.
    Valenti, M.C.: Iterative channel estimation for turbo codes over fading channels. In: IEEE Wireless Communications and Networking Conference, vol. 3, pp. 23–28, 1019–1024, September 2000Google Scholar
  8. 8.
    Yeap, L., Wong, C., Hanzo, L.: Reduced complexity inphase/quadrature-phase M-QAM turbo equalization using iterative channel estimation. IEEE Trans. Wirel. Commun. 2(1), 2–10 (2003)CrossRefGoogle Scholar
  9. 9.
    Song, S., Singer, A.C., Sung, K.-M.: Turbo equalization with an unknown channel. In: Proceedings of IEEE International Conference on Acoustics, Speech and Signal Processing, vol. 3 (2002)Google Scholar

Copyright information

© Springer Nature Switzerland AG 2020

Authors and Affiliations

  1. 1.Electronics and Communication EngineeringPSCMRCETVijayawadaIndia

Personalised recommendations