Materials Processing Fundamentals 2019 pp 59-70 | Cite as
Optimization of the Flow Behavior of Molten Steel in Ultrahigh-Speed Billet Continuous Casting Mold
Abstract
Ultrahigh casting speed is an important tendency to improve the efficiency of continuous casting. A three-dimensional mathematical model and a hydraulic physical model on the billet mold with 160 × 160 mm cross section were established to investigate the flow behavior of molten steel with different SEN conditions and optimize the parameters of SEN at the casting speed of 6.0 m/min. Results indicate that when the immersion depth and the inner diameter of the SEN are 180 and 50 mm, respectively, the flow field and the surface velocity distribution in the mold are the most appropriate that the penetration depth of the stream is about 700 mm and the maximum surface velocity is 0.05 m/s. With the optimum parameters of SEN, the slag covers uniformly and keeps appropriately active, and no slag entrainment happens. Moreover, the differences are very slight between the results of the numerical and physical simulation, which can verify each other.
Keywords
Ultrahigh-speed continuous casting Fluid flow Numerical simulation Hydraulic simulation SEN parametersNotes
Acknowledgements
The work is financially supported by the Natural Science Foundation of China, Project No. 51374260 and 51504048.
References
- 1.Chow C, Samarasekera IV (2013) High speed continuous casting of steel billets: Part 1: General overview. Ironmaking Steelmaking 29(1):53–60CrossRefGoogle Scholar
- 2.Chow C, Samarasekera IV, Walker BN, Lockhart G (2013) High speed continuous casting of steel billets: Part 2: Mould heat transfer and mould design. Ironmaking Steelmaking 29(1):61–69CrossRefGoogle Scholar
- 3.Li C, Thomas BG (2002) Maximum casting speed for continuous cast steel billets based on sub-mold bulging computation. Paper presented at 85th Steelmaking Conference, Nashville, 10–13 March, 2002Google Scholar
- 4.Thomas BG, Mika LJ, Najjar FM (1990) Simulation of fluid flow inside a continuous slab-casting machine. Metall Trans B 21(2):387–400CrossRefGoogle Scholar
- 5.Lait JE, Brimacombe JK, Weinberg F (1974) Mathematical modeling of heat flow in the continuous casting of steel. Ironmaking Steelmaking 1(2):90–97Google Scholar
- 6.Ho YH, Chen CH, Hwang WS (2007) Analysis of molten steel flow in slab continuous caster mold. ISIJ Int 34(3):255–264CrossRefGoogle Scholar
- 7.Zhu M (1997) Numerical simulation of the coupled molten steel flow and heat transfer in continuous casting tundishes. Acta Metall Sin 33(9):933–938Google Scholar
- 8.Ren B, Zhu M, Wang H, Chen Y (2008) 3D numerical simulation of electromagnetic field and flow field in bloom continuous casting mold with electromagnetic stirring. Acta Metall Sin 44(4):507–512Google Scholar
- 9.Zheng S (2006) Water model study on removing inclusion in a ladle with argon injected through nozzle and porous plug. Acta Metall Sin 42(11):1143–1148Google Scholar
- 10.Jin X, Chen DF, Xie X, Shen J, Long M (2013) Investigation on water model for fluid flow in slab continuous casting mold with consideration of solidified process. Steel Res Int 84(1):31–39CrossRefGoogle Scholar
- 11.Zhang L, Yang S, Cai K, Jiying LI, Wan X, Thomas BG (2007) Investigation of fluid flow and steel cleanliness in the continuous casting strand. Metall Mater Trans B 38(1):63–83CrossRefGoogle Scholar