Advertisement

Degradation of Silicone Rubber Analyzed by Instrumental Analyses and Dielectric Spectroscopy

  • Yoshimichi OhkiEmail author
  • Naoshi Hirai
  • Daomin Min
  • Liuqing Yang
  • Shengtao Li
Conference paper
Part of the The Minerals, Metals & Materials Series book series (MMMS)

Abstract

Silicone rubber (SiR) was gamma irradiated at 125, 145 and 185 °C or thermally aged at 220, 250 and 280 °C and the resultant changes in performance were evaluated. It has become clear from instrumental analyses that crosslinking via oxidation of silicon atoms and chain scission are induced by gamma rays. Furthermore, from the temperature dependence of real relative permittivity at high frequencies, the thermal expansion coefficient was found to become smaller with the increase in dose. These results can be understood well by the chemical and structural changes in SiR induced by the degradation.

Keywords

Degradation Aging Complex permittivity Gamma rays SiR High temperature 

References

  1. 1.
    Japan Nuclear Energy Safety Organization, The Final Report of the Project of ‘Assessment of Cable Aging for Nuclear Power Plants (Report JNES-SS-0903, 2009), pp. 1–4Google Scholar
  2. 2.
    A. Shimada et al., Degradation Distribution in insulation materials of cables by accelerated thermal and radiation ageing. IEEE Trans. Dielectr. Electr. Insul. 20(6), 2107–2116 (2013)CrossRefGoogle Scholar
  3. 3.
    Y. Ohki, N. Hirai, Effects of the structure and insulation material of a cable on the ability of a location method by FDR. IEEE Trans. Dielectr. Electr. Insul. 23(1), 77–84 (2016)CrossRefGoogle Scholar
  4. 4.
    Y. Ohki, T. Yamada, N. Hirai, Precise location of the excessive temperature points in polymer insulated cables. IEEE Trans. Dielectr. Electr. Insul. 20(6), 2099–2106 (2013)CrossRefGoogle Scholar
  5. 5.
    Brookhaven National Laboratory, Assessment of Environmental Qualification Practices and Condition Monitoring Techniques for Low-Voltage Electric Cables: Condition Monitoring Test Results (Report NUREG/CR-6704, vol. 2, United States Nuclear Regulation Commission, 2000), pp. 6(1)–6(3)Google Scholar
  6. 6.
    International Electrotechnical Commission, Nuclear Power Plants—Instrumentation and Control Important to Safety—Electrical Equipment Condition Monitoring Methods—Part 3: Elongation at Break (Standard IEC/IEEE 62582-3, 2012)Google Scholar
  7. 7.
    L.X. Zhang et al., Damage Effects and mechanisms of proton irradiation on methyl silicone rubber. Mater. Chem. Phys. 83, 255–259 (2004)CrossRefGoogle Scholar
  8. 8.
    X.T. Li et al., Space charge formation and charge transport in epoxy resin at varied temperatures. IEEJ Trans. Fundam. Mater. 135(2), 88–93 (2015)CrossRefGoogle Scholar
  9. 9.
    S. Hanada et al., Experimental investigation of the degradation mechanism of silicone rubber exposed to heat and gamma rays. High Voltage (2017). doi: https://doi.org/10.1049/hve.2017.0009 CrossRefGoogle Scholar
  10. 10.
    A. Labouriau et al., NMR and ATR-FTIR spectroscopic investigation of degradation in RTV siloxane foams. Polym. Degrad. Stab. 92(3), 285–292 (2006)Google Scholar
  11. 11.
    T. Izutsu et al., Estimation of talc contents in ethylene-propylene-diene copolymer by terahertz absorption spectroscopy. IEEJ Trans. Fundam. Mater. 136(2), 81–85 (2016)CrossRefGoogle Scholar
  12. 12.
    International Electrotechnical Commission, Nuclear Power Plants—Instrumentation and Control Important to Safety—Electrical Equipment Condition Monitoring Methods—Part 2: Indenter Modulus (Standard IEC/IEEE 62582-2, 2016)Google Scholar
  13. 13.
    International Standardization Orgnization, Rubber, Vulcanized or Thermoplastic-Determination of Tensile Stress-Strain Properties (Standard ISO 37, 2011)Google Scholar
  14. 14.
    A.A. Miller, Radiation chemistry of poly-dimethyl-siloxane. I. crosslinking and gas yields. J. Am. Chem. Soc. 82(14), 3519–3523 (1960)CrossRefGoogle Scholar
  15. 15.
    D. Min et al., Dielectric spectroscopic analysis of degradation in ethylene-propylene-diene copolymer. IEEE Trans. Dielectr. Electr. Insul. 23(6), 3620–3630 (2016)CrossRefGoogle Scholar
  16. 16.
    Friedrich Kremer, Andreas Schonhals, Broadband Dielectric Spectroscopy (Springer, Berlin, 2003)CrossRefGoogle Scholar
  17. 17.
    Y. Hasegawa, J. Takihana, Y. Ohki, Estimation of thermal expansion coefficients of polymeric insulating films from temperature dependence of dielectric permittivity. Jpn. J. Appl. Phys. 53(7), 071501(1)–071501(4) (2014)CrossRefGoogle Scholar

Copyright information

© The Minerals, Metals & Materials Society 2019

Authors and Affiliations

  • Yoshimichi Ohki
    • 1
    • 2
    • 3
    Email author
  • Naoshi Hirai
    • 2
  • Daomin Min
    • 2
    • 3
  • Liuqing Yang
    • 2
    • 3
  • Shengtao Li
    • 3
  1. 1.Department of Electrical Engineering and BioscienceWaseda UniversityShinjuku, TokyoJapan
  2. 2.Research Institute for Materials Science and Technology, Waseda UniversityShinjuku, TokyoJapan
  3. 3.State Key Laboratory of Electrical Insulation and Power EquipmentXi’an Jiaotong UniversityXi’anChina

Personalised recommendations