Presents 3D printers as a professional tool for robotics design in industrial applications
Presents 3D design principles: special chapters on costumizing robotics
Includes homemade robotics guidelines for start-up companies
Table of contents (10 chapters)
-
-
- Fernando Auat, Pablo Prieto, Gualtiero Fantoni
Pages 1-6
-
-
-
-
- Daniele Mazzei, Lorenzo Cominelli, Nicole Lazzeri
Pages 85-114
-
- Matteo Cianchetti, Mariangela Manti, Marcello Calisti, Cecilia Laschi
Pages 115-136
-
- Michelle Viscaíno, Javier Romero, Fernando Auat
Pages 137-159
-
- María-José Escobar, Frédéric Alexandre, Thierry Viéville, Adrian Palacios
Pages 161-194
-
- Sheila Lascano, Danilo Estay
Pages 195-219
-
- Fernando Auat, Pablo Prieto
Pages 221-223
About this book
This book summarizes recent advances in robotics using 3D printers and rapid prototyping as a concept development tool. The book is focused on industrial applications, educational aspects, rehabilitation, and other related topics. In particular, the book is intended to offer the reader a smooth yet deep introduction to the use of 3D printers and rapid prototyping techniques as a solution to robotics and mechatronics problems, highlighting successful case studies.
Keywords
- Additive Manufacturing
- Haptic by Rapid Prototyping
- Homemade Robotics
- Mobile and Service Robots
- Rapid Robotics
Editors and Affiliations
-
Department of Electronic Engineering, Universidad Técnica Federico Santa María, Valparaíso, Chile
Fernando Auat
-
Department of Engineering Design, Universidad Técnica Federico Santa María, Valparaíso, Chile
Pablo Prieto
-
Research Center E. Piaggio Faculty of Engineering, University of Pisa, Pisa, Italy
Gualtiero Fantoni