Advertisement

Molding of Thermosetting Plastics

  • Authors
  • Tony Whelan
  • John Goff

Table of contents

  1. Front Matter
    Pages 1-4
  2. Tony Whelan, John Goff
    Pages 5-9
  3. Tony Whelan, John Goff
    Pages 10-16
  4. Tony Whelan, John Goff
    Pages 17-25
  5. Tony Whelan, John Goff
    Pages 26-32
  6. Tony Whelan, John Goff
    Pages 33-42
  7. Tony Whelan, John Goff
    Pages 43-51
  8. Tony Whelan, John Goff
    Pages 52-58
  9. Tony Whelan, John Goff
    Pages 59-66
  10. Tony Whelan, John Goff
    Pages 67-74
  11. Tony Whelan, John Goff
    Pages 75-85
  12. Tony Whelan, John Goff
    Pages 86-93
  13. Back Matter
    Pages 94-131

About this book

Introduction

During the years 1987 and 1988 we published a series of articles on the molding of thermoplastics materials in the magazine British Plastics and Rubber (B P & R). These articles were very well received and we also received a large number of requests for reprints. In order to cater for what is obviously a need in the thermoplas­ tics molding industry, we therefore brought the information together and produced it in the form of a book. We can only hope that it serves you well and that you find the information useful. We in turn would like to thank the editor of the magazine B P & R for helping us in this matter. Thanks are also due to our many friends and colleagues throughout the molding industry for their useful help and advice, in particular the company Moldflow (Europe) limited deserve a special mention as they allowed us to extract information from their extensive data base.

Keywords

Compound Diallylphthalat Elastomer MF Polymer SMC Sheet molding compound UF polyester polymers

Bibliographic information