Advertisement

Residual Stress and Its Effects on Fatigue and Fracture

Proceedings of a Special Symposium held within the 16th European Conference of Fracture – ECF16, Alexandroupolis, Greece, 3-7 July 2006

  • A.G. Youtsos

Table of contents

  1. Front Matter
    Pages I-X
  2. Residual Stress Analysis by Modelling Techniques

    1. Front Matter
      Pages 1-1
    2. L.K. Keppas, N.K. Anifantis, D.E. Katsareas, A.G. Youtsos
      Pages 27-39
  3. Residual Stress Analysis by Experimental Methods

    1. Front Matter
      Pages 53-53
    2. J.D. Puerta Velásquez, B. Bolle, P. Chevrier, A. Tidu
      Pages 87-95
    3. O. Uca, C. Ohms, A.G. Youtsos
      Pages 97-101
  4. Residual Stress Analysis by Modelling Techniques

    1. Front Matter
      Pages 103-103
    2. S K Bate, R Charles, D Everett, D O’Gara, A Warren, S Yellowlees
      Pages 105-115
    3. K. Babski, T. Boguszewski, A. Boczkowska, M. Lewandowska, W. Swieszkowski, K.J. Kurzydlowski
      Pages 139-148
  5. Residual Stress Effects on Fatigue and Fracture

    1. Front Matter
      Pages 161-161
    2. A. Mirzaee-Sisan, M. C. Smith, C. E. Truman, D. J. Smith
      Pages 177-187
    3. Dimitris C. Lagoudas, Olivier W. Bertacchini, E Patoor
      Pages 209-222
    4. A.H. Sherry, J Quinta da Fonseca, K Taylor, M.R. Goldthorpe
      Pages 223-232
  6. Back Matter
    Pages 233-234

About these proceedings

Introduction

Simplified fracture mechanics based assessment methods are widely used by the industry to determine the structural integrity significance of postulated cracks, manufacturing flaws, service-induced cracking or suspected degradation of engineering components under normal and abnormal service loads. In many cases, welded joints are the regions most likely to contain original fabrication defects or cracks initiating and growing during service operation. Various procedures provide upper bound residual stress profiles for various classes of welded joints that can be used in fracture assessments, but these often give very conservative results. Recently, the option to use more realistic profiles has been adopted, but only where such profiles are based on finite element residual stress simulations supported by detailed residual stress measurements. Rapid advances in the capability of residual stress measurement techniques, such as the contour and deep hole drilling techniques as well as the neutron and synchrotron X-ray diffraction methods, now readily allow residual stresses and strains to be mapped on defined planes within a structure. The contents of this book have been grouped into three topic areas covering theoretical /numerical and experimental analyses of residual stress and its effects on fatigue and fracture.

Keywords

Uran alloy development diffraction fatigue fracture mechanics modeling polymer simulation

Editors and affiliations

  • A.G. Youtsos
    • 1
  1. 1.Joint Research CentreThe Institute for Energy(IE)PettenThe Netherlands

Bibliographic information