Advertisement

Bonding in Microsystem Technology

  • Jan A. Dziuban

Part of the Springer Series in Advanced Microelectronics book series (MICROELECTR., volume 24)

Table of contents

About this book

Introduction

Bonding in Microsystem Technology starts with descriptions of terminology, kinds of microsystems and market analysis. Followed by the presentation of mechanisms of wet etching, set of process parameters, description of micromachining methods, examples of procedures, process flow-charts and applications of basic micromechanical structures in microsystems are shown. Next, high-temperature, low temperature and room-temperature bonding and their applications in microsystem technology are presented. The following part of the book contains the detailed description of anodic bonding, starting from analysis of properties of glasses suitable for anodic bonding, and discussion of the nature of the process. Next all types of anodic bonding and sealing procedures used in microsystem technology are presented. This part of the book finishes with examples of applications of anodic bonding in microsystem technology taken from the literature but mainly based on the author’s personal experience.

Keywords

Natur bonding/anodic bonding deep micromachining design development electronics glass machining microelectromechanical system (MEMS) microengineering microsystems silicon technology

Authors and affiliations

  • Jan A. Dziuban
    • 1
  1. 1.Faculty of Microsystems Electronics and PhotonicsWrocław University of TechnologyWrocławPoland

Bibliographic information

  • DOI https://doi.org/10.1007/1-4020-4589-1
  • Copyright Information Springer 2006
  • Publisher Name Springer, Dordrecht
  • eBook Packages Engineering
  • Print ISBN 978-1-4020-4578-3
  • Online ISBN 978-1-4020-4589-9
  • Series Print ISSN 1437-0387
  • Buy this book on publisher's site