Advertisement

© 2011

Manufacturing Processes 1

Cutting

Book

Part of the RWTHedition book series (RWTH)

Table of contents

  1. Front Matter
    Pages i-xviii
  2. Fritz Klocke, Aaron Kuchle
    Pages 1-2
  3. Fritz Klocke, Aaron Kuchle
    Pages 3-37
  4. Fritz Klocke, Aaron Kuchle
    Pages 39-94
  5. Fritz Klocke, Aaron Kuchle
    Pages 95-196
  6. Fritz Klocke, Aaron Kuchle
    Pages 197-217
  7. Fritz Klocke, Aaron Kuchle
    Pages 219-236
  8. Fritz Klocke, Aaron Kuchle
    Pages 237-337
  9. Fritz Klocke, Aaron Kuchle
    Pages 339-382
  10. Fritz Klocke, Aaron Kuchle
    Pages 383-444
  11. Fritz Klocke, Aaron Kuchle
    Pages 445-467
  12. Back Matter
    Pages 469-504

About this book

Introduction

The book series on manufacturing processes for engineers is a reference work for scientific and industrial experts. This volume on Turning, Milling and Drilling starts from the basic principles of machining with geometrically defined cutting edges based on a common active principle. In addition, appropriate tool designs as well as the reasonable use of cutting material are presented. A detailed chapter about the machinability of the most important workpiece materials, such as steel and cast iron, light metal alloys and high temperature resistant materials imparts a broad knowledge of the interrelations between workpiece materials, cutting materials and process parameters.

This book is in the RWTHedition Series as are the other four volumes of the reference work.

Keywords

EBM ECM EDM LBM calibration casting process chemical removing component generation contruction guidelines cooling lubricants cutting material electro-discharge machining electrochemical machining grindability high pressure water jet lamination manufacturing technology metal powder powder forging powder metallurgy sheet metal forming symbols tools

Authors and affiliations

  1. 1.der RWTH Aachen, Lehrstuhl fürWerkzeugmaschinenlabor (WZL)AachenGermany

About the authors

Professor Dr.-Ing. Dr.-Ing. E.h. Dr. h.c. Dr. h.c. Fritz Klocke has been Professor of Manufacturing Engineering Technology, director of the WZL Laboratory for Machine Tools & Production Engineering at the RWTH Aachen University, and head of the Fraunhofer Institute for Production Technology IPT in Aachen since 1995.

A doctorate of honoris causa “Dr. E.h.” was bestowed upon him by the University of Hannover in 2006, a second doctorate of honoris causa “Dr. h.c.” was bestowed upon him by the Aristotle University of Thessaloniki in 2009 and a third doctorate of honoris causa “Dr. h.c.” was bestowed upon him by the Keio University of Tokyo in 2010.

Professor Klocke was CIRP President from 2007–2008.

Bibliographic information