The Boundary Element Method with Programming

For engineers and scientists

  • Gernot Beer
  • Ian M. Smith
  • Christian Duenser

Table of contents

About this book


This is a sequel to the book “Programming the Boundary Element Method” by G. Beer published by Wiley in 2001. The scope of this book is different however and this is reflected in the title. Whereas the previous book concentrated on explaining the implementation of a limited range of problems into computer code and the emphasis was on programming, in the current book the problems covered are extended, the emphasis is on explaining the theory and computer code is not presented for all topics. The new topics covered range from dynamics to piezo-electricity. However, the main idea, to provide an explanation of the Boundary Element Method (BEM), that is easy for engineers and scientists to follow, is retained. This is achieved by explaining some aspects of the method in an engineering rather than mathematical way. Another new feature of the book is that it deals with the implementation of the method on parallel processing hardware. I. M. Smith, who has been involved in programming the finite element method for decades, illustrates that the BEM is “embarrassingly parallelisable”. It is shown that the conversion of the BEM programs to run efficiently on parallel processing hardware is not too difficult and the results are very impressive, such as solving a 20 000 element problem during a “coffee break”.


Analysis Software Transformation electricity mechanical engineering modeling programming wave equation

Authors and affiliations

  • Gernot Beer
    • 1
  • Ian M. Smith
    • 2
  • Christian Duenser
    • 3
  1. 1.Institute for Structural AnalysisGraz University of TechnologyAustria
  2. 2.University of ManchesterUK
  3. 3.Institute for Structural AnalysisGraz University of TechnologyAustria

Bibliographic information