Abstract
Upcut milling of plane surfaces is investigated. To increase the accuracy of the machined surface, the cutting force vector must be taken into account. That vector depends on the cutting depth and the mill diameter.
REFERENCES
Ignatov, M.G., Babin, S.V., and Perminov, A.E., Variation in the vertical cutting force in opposed milling, Vestn. Mashinostr., 2006, no. 1, pp. 75–76.
Perminov, A.E., Babin, S.V., and Prokof’ev, E.Yu., Machining with end mills, Russ. Eng. Res., 2018, vol. 38, pp. 180–181. https://doi.org/10.3103/S1068798X18030164
Timiryazev, V.A., Khostikoev, M.Z., Danilov, I.K., and Datsko, A.G., Controlling the accuracy in contour milling, Russ. Eng. Res., 2021, vol. 41, pp. 262–265. https://doi.org/10.3103/S1068798X21030187
Ignatov, M.G., Perminov, A.E., and Prokof’ev, E.Yu., Influence of the vertical cutting force on the surface precision and roughness in opposed milling, Russ. Eng. Res., 2008, vol. 28, pp. 864–865. https://doi.org/10.3103/S1068798X08090074
Funding
This work was supported by ongoing institutional funding. No additional grants to carry out or direct this particular research were obtained.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
The authors of this work declare that they have no conflicts of interest.
Additional information
Translated by B. Gilbert
Publisher’s Note.
Allerton Press remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
About this article
Cite this article
Babin, S.V., Ignatov, M.G. & Perminov, A.E. Upcut Milling. Russ. Engin. Res. 44, 376–377 (2024). https://doi.org/10.3103/S1068798X24700370
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X24700370