Abstract
Experience is analyzed and the possibilities of replacing high-speed steel in the manufacture of knurling tool with high-chromium steels are shown. The modes of heat treatment and forging treatment in the manufacture of billets for cylindrical knurls are given.
This is a preview of subscription content, log in via an institution to check access.
REFERENCES
Kalpin, Yu.G., Development of the generalized theory of the technology of volumetric isothermal stamping, Doctoral (Eng.) Dissertation, Moscow: Bauman Moscow State Tech. Univ., 1987.
Vinogradov, V.M., Cherepakhin, A.A., and Buyanov, A.S., Kholodnoe kalibrovanie zub’ev tsilindricheskikh zubchatykh koles avtomobil’nykh transmissii i dvigatelei (Cold Calibration of Spur Gear Teeth of Automotive Transmissions and Engines), Moscow: Forum, 2011.
Filippov, Yu.O., Eremin, E.N., Losev, A.S., et al., Structure and properties of high chromium steels modified with refractory particles, Omsk. Vestn., 2007, no. 2 (56), pp. 101–103.
Funding
This work was supported by ongoing institutional funding. No additional grants to carry out or direct this particular research were obtained.
Author information
Authors and Affiliations
Corresponding authors
Ethics declarations
The authors of this work declare that they have no conflicts of interest.
Additional information
Translated by I. Obrezanova
Publisher’s Note.
Allerton Press remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
About this article
Cite this article
Cherepakhin, A.A., Lyalyakin, V.P. Features of the Choice of Knurl Material for Cold Calibration of Cylindrical Mid-Module Gear Wheels. Russ. Engin. Res. 44, 74–77 (2024). https://doi.org/10.3103/S1068798X24010106
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X24010106