Abstract
On the basis of plastic flow theory, the determination of the kinematic and stress state of a workpiece in constrained channel extrusion is considered for plane deformation with misalignment of the punch and matrix. The flow rate and stress are determined in the plastic deformation region under the punch and close to the thick channel wall that forms. Formulas are obtained for the extrusion parameters of unequal channels with a thin horizontal floor.
This is a preview of subscription content, log in via an institution to check access.
REFERENCES
Vorontsov, A.L., Stamping of nonuniform channels. 7. Kinematic and stress states of the workpiece under constrained extrusion. 1. Plastic area under the resulting thick wall, Vestn. Mashinostr., 2023, no. 1, pp. 69–74. https://doi.org/10.36652/0042-4633-2023-102-1-69-74
Vorontsov, A.L., Teoriya i raschety protsessov obrabotki metallov davleniem (Theory and Calculations of Metal Forming by Pressure), Moscow: Bauman Moscow State Tech. Univ., 2014, vol. 1.
Vorontsov, A.L., Teoriya i raschety protsessov obrabotki metallov davleniem (Theory and Calculations of Metal Forming by Pressure), Moscow: Bauman Moscow State Tech. Univ., 2014, vol. 2.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
The author declares that he has no conflicts of interest.
Additional information
Translated by B. Gilbert
For the first part of this analysis, see Russian Engineering Research, no. 4, 2023.
About this article
Cite this article
Vorontsov, A.L. Stamping of Nonuniform Channels. 7. Kinematic and Stress State of the Workpiece in Constrained Extrusion. 7.2. Plastic Region under the Punch and Close to the Thick Wall. Russ. Engin. Res. 43, 567–570 (2023). https://doi.org/10.3103/S1068798X23050465
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X23050465