Skip to main content
SpringerLink
Log in

Measurement of Shaft Deformation in Magnetorheological Couplings

  • Published:
Russian Engineering Research Aims and scope

Abstract

A method is proposed for determining the maximum shear strain and stress of elastic shafts in magnetorheological couplings, on the basis of the finite-element method. To determine the angular mismatch of the coupling, the torque may be established by measuring the torsional deformation of the shafts, using broad-band frequency modulation.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
Fig. 5.
Fig. 6.

REFERENCES

  1. Vanyagin, A.V., Gordeev, B.A., Erofeev, V.I., and Okhulkov, S.N., Reduced intensity of torque shaft oscillations using magnetoreological couplings, Vestn. Nauchno-Tekh. Razvit., 2020, no. 1 (149), pp. 11–22. https://doi.org/10.18411/vntr2020-149-2

  2. Okhulkov, S.N., Plekhov, A.S., Titov, D.Yu., and Shevyrev, Yu.V., Metody i ustroistva oslableniya vibratsii elektromekhanicheksikh kompleksov: Monografiya (Methods and Devices for Reduction of Vibration of Electromechanical Complexes: Monograph), Nizhny Novgorod: Alekseev Nizhny Novgorod State Tech. Univ., 2016.

  3. Makvetsov, E.N. and Tartakovskii, A.M., Mekhanicheskie vozdeistviya i zashchita radioelektronnoi apparatury (Mechanical Effects and Protection of Radio Electronic Equipment), Moscow: Radio i Svyaz’, 1993.

  4. Dmitriev, S., Daryenkov, A., German, L., et al., Torque sensors calibration of electromechanical complexes shafts, Vibroeng. Procedia, 2018, vol. 21, pp. 190–195. https://doi.org/10.21595/vp.2018.20355

    Article  Google Scholar 

  5. Sapozhnikov, D.V., Calculation method of the frequency discriminator delay line, Rossiya Molod., Ser. Peredov. Tekhnol. – Prom-st., 2017, no. 1, pp. 280–282.

  6. Red, E.T., Arbeitsbuch für den HF-Techniker: Daten, Fakten, HF-Grundschaltungen, 50-Ohm-Technik, München: Franzis, 1986.

    Google Scholar 

  7. Viktorov, V.A., Lunkin, B.V., and Sovlukov, A.S., Radiovolnovye izmereniya parametrov tekhnologicheskikh protsessov (Radio Wave Measurements of Technological Parameters), Moscow: Energoizdat, 1989.

  8. Gordeev, B.A., Okhulkov, S.N., Plekhov, A.S., and Shokhin, A.E., Torque on a shaft connected to the driveshaft by a magnetorheological coupling, Russ. Eng. Res., 2018, vol. 38, pp. 962–967. https://doi.org/10.3103/S1068798X18120377

    Article  Google Scholar 

  9. Gordeev, B.A., Okhulkov, S.N., Plekhov, A.S., Bugaiskii, V.V., and Gorskov, V.P., Measuring the torque of rotating shafts, Russ. Eng. Res., 2015, vol. 35, pp. 315–319. https://doi.org/10.3103/S1068798X15050147

    Article  Google Scholar 

  10. Kasatkin, B.S., Kudrin, A.B., Lobanov, L.M., et al., Eksperimental’nye metody issledovaniya deformatsii i napryazhenii: Spravochnoe posobie (Experimental Investigation of Stress and Strain: Handbook), Kiev: Naukova Dumka, 1981.

  11. Alekseev, V.V., Bolotin, F.F., and Kortyn, G.D., Demfirovanie kolebanii v sudovykh valoprovodakh (Damping of Vibration in Ship Shafts), Leningrad: Sudostroenie, 1973.

  12. Pokusaev, M.N., Sibryaev, K.O., and Shevchenko, A.V., Experimental determination of the degree of irregular rotation of a shaft in the propulsion unit of ship design N 1557, Vestn. Astrakhansk. Gos. Tekh. Univ. Ser. Mor. Tekh. Tekhnol., 2008, no. 2 (43), pp. 140–144.

  13. Belov, L.A., Components of stable frequency synthesizers. Voltage controlled oscillators, Elektron.: Nauka, Tekhnol., Biznes, 2004, no. 1, pp. 42–46.

  14. Belov, L.A., Ustroistva formirovaniya SVCh signalov i ikh komponenty (Microwave Signal Conditioning Devices and Components), Moscow: Mosk. Energ. Inst., 2010.

Download references

Funding

The work was supported by the state task for fundamental scientific research, agreement no. FFUF- 2021-0025.

Author information

Authors and Affiliations

  1. Federal Research Center A.V. Gaponov-Grekhov Institute of Applied Physics, Russian Academy of Sciences, 603950, Nizhny Novgorod, Russia

    A. V. Vanyagin

  2. Mechanical Engineering Research Institute, Russian Academy of Sciences, 101990, Nizhny Novgorod, Russia

    B. A. Gordeev, A. I. Ermolaev & S. N. Okhulkov

  3. Alekseev Nizhny Novgorod State Technical University, 603155, Nizhny Novgorod, Russia

    A. S. Plekhov

Authors
  1. A. V. Vanyagin
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. B. A. Gordeev
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. A. I. Ermolaev
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. S. N. Okhulkov
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. A. S. Plekhov
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding authors

Correspondence to A. V. Vanyagin, B. A. Gordeev, A. I. Ermolaev, S. N. Okhulkov or A. S. Plekhov.

Ethics declarations

The authors declare that they have no conflicts of interest.

Additional information

Translated by B. Gilbert

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Vanyagin, A.V., Gordeev, B.A., Ermolaev, A.I. et al. Measurement of Shaft Deformation in Magnetorheological Couplings. Russ. Engin. Res. 43, 561–566 (2023). https://doi.org/10.3103/S1068798X23050453

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.3103/S1068798X23050453

Keywords:

Search

Navigation