Abstract
A method of calculating the cut-layer thickness is proposed in computer modeling of the milling of a screw surface.
REFERENCES
Lashnev, S.I. and Yulikov, M.I., Proektirovanie rezhushchei chasti instrumenta s primeneniem EVM (Designing the Cutting Part of the Tool Using a Computer), Moscow: Mashinostroenie, 1978.
Petrov, S.M., Davletshina, G.K., and Zairov, B.F., Modeling of helical surface shaping with a disk tool, Materialy X mezhdunarodnoi nauchno-tekhnicheskoi konferentsii “Innovatsionnye mashinostroitel’nye tekhnologii, oborudovanie i materialy” (MNTK IMTOM-2019) (Proc. X Sci.-Tech. Conf. on Innovative Engineering Technologies, Equipment and Materials (ISTC-IETEM-2019)), Kazan, 2019, Chap. 2, pp. 96–100.
Petrov, S.M., Davletshina, G.K., Zairov, B.F., and Zairov, L.F., Cutter profile of a mill for machining screw channels, Russ. Eng. Res., 2017, vol. 37, pp. 728–729. https://doi.org/10.3103/S1068798X17080147
Grechishnikov, V.A., Chemborisov, N.A., Akhmet-shin, I.R., and Nizamov, A.Kh., Computer simulation of combined cross-sections for determination of the disk tool profile processing the screw surfaces of workpieces, Tezisy dokladov nauchno-tekhnicheskoi konferentsii “Tekhnologicheskie problemy proizvodstva letatel’nykh apparatov i dvigatelei” (Abstr. Works Sci.-Tech. Conf. “Technological Problems in Production of Aircrafts and Engines”), K-azan: Kazan. Gos. Tekh. Univ., 1993.
Author information
Authors and Affiliations
Corresponding authors
Ethics declarations
The authors declare that they have no conflicts of interest.
Additional information
Translated by B. Gilbert
About this article
Cite this article
Petrov, S.M., Davletshina, G.K. & Zairov, B.F. Determining the Cut-Layer Thickness in Simulating the Machining of a Screw Surface. Russ. Engin. Res. 43, 467–469 (2023). https://doi.org/10.3103/S1068798X23050180
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X23050180