Abstract
Analytical formulas are derived for the discrepancy in hole diameter on reaming due to the misalignment of the reaming and rotating axes, with rigid attachment of the reamer to the machine tool. These formulas may be used to optimize the input parameters in reaming and hence to obtain accurate holes.
REFERENCES
Zheleznov, G.S. and Andreeva, S.G., Influence of elastic recoil on the hole precision when reaming thin-walled components, Russ. Eng. Res., 2017, vol. 37, pp. 704–707. https://doi.org/10.3103/S1068798X17080226
Utkin, N.F., Kizhnyaev, Yu.I., Pluzhnikov, S.K., et al., Obrabotka glubokikh otverstii (Deep Hole Machining), Utkin, N.F., Ed., Leningrad: Mashinostroenie, 1988.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by B. Gilbert
About this article
Cite this article
Zheleznov, G.S., Shirokov, A.V. Hole Accuracy in Reaming. Russ. Engin. Res. 43, 223–225 (2023). https://doi.org/10.3103/S1068798X23040378
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X23040378