Abstract
In practice, it is important to assess the nonuniformity of the crankshaft speed in internal combustion engines. In such assessments, the sensitivity of the chosen criteria to the following factors is of particular interest: the spread of the maximum pressure; and the spread in the operational characteristics in successive working cycles. In the present work, the criteria and operational characteristics are calculated in idling. A unique relation between the deviations in successive working cycles and the nonuniformity of the crankshaft speed is only possible in idling [1]. The following criteria are considered: the variation in the increment in crankshaft speed over the cycle in a sequence of operational cycles; the variation of the maximum crankshaft speed (its amplitude); the variation of the set of maximum and minimum crankshaft speeds; and the relation between the real and kinematic nonuniformity of the crankshaft speed.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
REFERENCES
Prikhod’kov, K.V., Lyutin, K.I., Osin, V.V., and Av-deyuk, D.N., Research of work process variability in engine VAZ-11194 through indicated diagrams, Energ. Resursosber.: Prom-st. Transp., 2016, no. 4 (16), pp. 24–28.
Agureev, I.E. and Agromeshin, A.V., Investigation of intercycle non-identity of internal combustion engines: Nature of occurrence, management, impact on workflow, Materialy VI Vserossiiskoi nauchno-tekhnicheskoi konferentsii “Politransportnye sistemy Sibiri” (Proc. 6th All-Russian Sci. and Tech. Conf. “Polytransport Systems of Siberia”), Novosibirsk: Sib. Gos. Univ. Putei Soobshch., 2009, part 1, pp. 12–18.
Fedyanov, E.A., Intercycle non-identity of the workflow and problems of improving the performance of internal combustion engines with spark ignition, Doctoral (Eng.) Dissertation, Volgograd, 1999.
Han, S.B., Cycle-to-cycle variations under cylinder pressure-based combustion analysis in spark ignition engines, Int. J. Korean Soc. Mech. Eng., 2000, vol. 14, no. 10, pp. 1151–1158.
Ceviz, M.A. and Yuksel, F., Cyclic variations on LPG and gasoline-fuelled lean burn SI engine, Renewable Energy, 2006, vol. 31, no. 12, pp. 1950–1960.
Safronov, P.V. and Marov, I.E., Software and hardware complex for the study of uneven rotation speed of the crankshaft of the internal combustion engine, Avtom. Prom-st., 2012, no. 2, pp. 31–33.
Safronov, P.V., Pershutin, E.A., Alekseev, I.V., et al., Onboard effective torque estimation using intercycle crankshaft angular speed variation, Vestn. Mosk. Avtom.-Dorozhn. Gos. Tekh. Univ. (MADI), 2012, no. 1 (28), pp. 50–56.
Shatrov, M.G., Morozov, K.A., Alekseev, I.V., et al., Avtomobil’nye dvigateli: Uchebnik dlya vuzov (Car Engines: Manual for Higher Education Institutions), Shatrov, M.G., Ed., Moscow: Akademiya, 2010.
Lukin, A.M. and Khavkin, V.I., USSR Inventor’s Certificate no. 1087802, Byull. Izobret., 1984, no. 15.
Stechkin, B.S., Genkin, K.I., and Zolotarevskii, V.S., Indikatornaya diagramma, dinamika teplovydeleniya i rabochii tsikl bystrokhodnogo porshnevogo dvigatelya (Indicator Diagram, Heat Release Dynamics and Duty Cycle of High-Speed Piston Engine), Moscow: Akad. Nauk SSSR, 1960.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by B. Gilbert
About this article
Cite this article
Safronov, P.V., Shatrov, M.G. & Golubkov, L.N. Assessing the Working-Cycle Fluctuation in Internal-Combustion Engines from the Nonuniformity of the Idling Speed. Russ. Engin. Res. 42, 1174–1177 (2022). https://doi.org/10.3103/S1068798X2211020X
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X2211020X