Abstract
Wave spring washers are often used to create preliminary axial tension in roller bearings. A method is proposed for calculating the washer parameters appropriate to a wide range of axial loads.
Similar content being viewed by others
REFERENCES
SKF General Catalog 6000 RU (2006).
Chermenskii, O.N. and Fedotov, N.N., Podshipniki kacheniya: Spravochnik-katalog (Rolling Bearings: Handbook-Catalogue), Moscow: Mashinostroenie, 2003.
Katalog pruzhin (Spring Catalog), St. Petersburg: NPO STAMO, 2014. www.STAMO.ru
Pisarenko, G.S., Yakovlev, A.P., and Matveev, V.V., Spravochnik po soprotivleniyu materialov (Handbook of Materials Resistance), Kiev: Naukova Dumka, 1975.
Ivanov, A.S., Konstruiruem mashiny shag za shagom (Design Machines Step by Step), 2 vols., Moscow: Bauman Moscow State Tech. Univ., 2003.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by B. Gilbert
About this article
Cite this article
Ivanov, A.S., Novikov, E.S. Determining the Parameters of Wave Spring Washers. Russ. Engin. Res. 42, 1117–1119 (2022). https://doi.org/10.3103/S1068798X22110107
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X22110107