Abstract
The influence of the type of abrasive and its granularity on the productivity and final surface roughness is studied for the lapping of cylindrical slides. Recommendations regarding the type of abrasive and its granularity are made, so as to ensure the required surface roughness with satisfactory productivity.
Similar content being viewed by others
REFERENCES
Yuan, J., Yao, W., Zhao, P., et al., Kinematics and trajectory of both-sides cylindrical lapping process in planetary motion type, Int. J. Mach. Tools Manuf., 2015, vol. 92, pp. 60–71.
Su, J., Yuan, J., Zhang, S., and Lv, B., Optimization experiment on eccentric lapping of cylindrical rollers, Natotechnol. Precis. Eng., 2018, vol. 1, pp. 197–204.
Muratov, K.R., Ablyaz, T.R., Gashev, E.A., and Rykunov, A.N., Software for simulating the surface wear of tools, Russ. Eng. Res., 2019, vol. 39, no. 10, pp. 869–871. https://doi.org/10.3103/S1068798X19100174
Funding
Financial support was provided by the Russian Ministry of Science and Higher Education (project FSNM-2020-0028).
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by B. Gilbert
About this article
Cite this article
Muratov, K.R., D’yakonov, A.A., Gashev, E.A. et al. Influence of Abrasive on the Productivity and Surface Roughness in Lapping. Russ. Engin. Res. 42, 832–834 (2022). https://doi.org/10.3103/S1068798X22080184
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X22080184