Abstract
A model is proposed for saw-disk wear in cotton-processing machines after shot hardening of the saw disk’s lateral tooth surfaces. The performance of saw disks with and without shot hardening is compared.
Similar content being viewed by others
REFERENCES
Miroshnichenko, G.I., Osnovy proektirovaniya mashin pervichnoi obrabotki khlopka: uchebnik dlya vuzov (Principles of Engineering of Mahcines for Primary Processing of Cotton: Manual for Higher Education Institutions), Moscow: Mashinostroenie, 1972.
Shin, I.G., Quality assurance and prediction of the durability of machine parts for primary processing of cotton, Extended Abstract of Doctoral (Eng.) Dissertation, Tashkent: Tashkent Inst. Tex. Light Ind., 2014.
Shin, I.G., Nazarov, S.R., Shodmonkulov, Z.A., and Muminov, M.R., Surface hardening of teeth of saw blades of cotton processing machines by shots, Vestn. Mashinostr., 2014, no. 7, pp. 81–85.
Khazov, B.F. and Didusev, B.A., Spravochnik po raschetu nadezhnosti mashin na stadii proektirovaniya (Handbook for Calculation of Reliability of Machines at the Design Stage), Moscow: Mashinostroenie, 1986.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by B. Gilbert
About this article
Cite this article
Shin, I.G., Nazarov, S.R., Iskandarova, N.K. et al. Wear and Life of Saw Disks for Preliminary Cotton Processing. Russ. Engin. Res. 41, 1115–1118 (2021). https://doi.org/10.3103/S1068798X21120388
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X21120388