Abstract
A model of the input channel is developed for a two-rotor Roots vacuum pump. In numerical calculations of the input-channel gas flow by means of Ansys Fluent software, for different input pressures, pressure differences, and rotor angles, the flow rate coefficients obtained for the gas are in good agreement with the experimental values.
Similar content being viewed by others
REFERENCES
NVD-200. https://vacma.ru/products/roots_ pump/nvd/382/.
Mamontov, M.A., Voprosy termodinamiki tela peremennoi massy (Thermodynamics of a Body with Variable Mass), Tula: Priokskoe Knizhn. Izd., 1970.
Burmistrov, A.V. and Salikeev, S.I., Beskontaktnye vakuumnye nasosy: uchebnoe posobie (Contactless Vacuum Pumps: Manual), Kazan: Kazan. Gos. Tekhnol. Univ., 2010.
Rong, C. and Wen, W., Discussion on leaking characters in meso-scroll compressor, Int. J. Refrig., 2009, vol. 32, no. 6, pp. 1433–1441.
Ooi, K.T. and Zhu, J., Convective heat transfer in a scroll compressor chamber: a 2-D simulation, Int. J. Therm. Sci., 2004, vol. 43, no. 7, pp. 677–688.
Lin, C., Chang, Y., Liang, K., and Hung, C., Temperature and thermal deformation analysis on scrolls of scroll compressor, Appl. Therm. Eng., 2005, vol. 25, nos. 11–12, pp. 1724–1739.
Bronshtein M.D., Raikov A.A., Burmistrov A.V., et al., Calculation of the conductivity of radial channels with moving walls in modeling of the processes in contactless vacuum pumps, Kompressornaya Tekh. Pnevmatika, 2017, no. 1, pp. 30–34.
Ibraev, A.M., The efficiency improvement of external compression rotary blowers based on the analysis of the influence of geometric parameters on their characteristics, Cand. Sci. (Eng.) Dissertation, Kazan: Kazan State Technol. Univ., 1987.
Raikov, A.A., Salikeev, S.I., and Burmistrov, A.V., Losses in the input and output ducts of a cam-toothed vacuum pump, Kompressornaya Tekh. Pnevmatika, 2009, vol. 8, pp. 13–18.
Raikov, A.A., Burmistrov, A.V., Salikeev, S.I., and Kapustin, E.N., Simulation of gas flow in the inlet and outlet ducts of a spiral vacuum pump, Materialy XXIII Nauchno-tekhnicheskaya konferentsiya s uchastiem zarubezhnykh spetsialistov “Vakuumanaya nauka i tekhnika,” 21–28 sentyabrya 2016 goda (Proc. XXIII Sci.-Tech. Conf. with Int. Participation “Vacuum Science and Tehcnology,” September 21–28, 2016), Moscow: Novella, 2016, pp. 70–74.
ANSYS license file for Kazan National Research Technology University no. 657938.
KOMPAS 3D v17. Rukovodstvo pol’zovatelya (KOMPAS 3D v17: User Guide), St. Petersburg: Askon, 2018.
Isaev, A.A., Raikov, A.A., Burmistrov, A.V., and Salikeev, S.I., Calculation of vacuum pumps of the Ruts type based on the energy balance of the thermodynamic system of a body with variable mass, Materialy 10-i Mezhdunarodnoi nauchno-tekhnicheskoi konferentsii “Tekhnika i tekhnologiya neftekhimicheskogo i neftegazovogo proizvodstva” (Proc. Tenth Int. Sci.-Tech. Conf. “Technique and Technology of Petrochemical and Oil and Gas Production”), Omsk: Omsk. Gos. Tekh. Univ., 2020, pp. 111–112.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by B. Gilbert
About this article
Cite this article
Isaev, A.A., Raikov, A.A., Burmistrov, A.V. et al. Losses in the Input Channel of a Two-Rotor Vacuum Pump. Russ. Engin. Res. 41, 1161–1164 (2021). https://doi.org/10.3103/S1068798X21120194
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X21120194