Abstract
The electrical discharge machining (EDM) of parts produced by additive technology is experimentally studied. The influence of wire-cut EDM on the final surface roughness of a titanium workpiece produced by additive technology is described by means of a regression equation.
Similar content being viewed by others
REFERENCES
Zlenko, M.A., Popovich, A.A., and Mutylina, I.N., Additivnye tekhnologii v mashinostroenii: Uchebnoe posobie (Additive Technologies in Machine Engineering: Manual), St. Petersburg: S.-Peterb. Gos. Politekh. Univ., 2013.
Shlykov, E.S. and Ablyaz, T.R., Wear of the electrode-tool during copy-piercing electrical discharge machining of bimetals, Sovrem. Probl. Nauki Obraz., 2015, no. 2-1. https://science-education.ru/ru/article/ view?id=20539.
Grisharin, A.O., Ablyaz, T.R., and Ogleznev, N.D., Efficiency of electrical discharge machining of hydraulic-cylinder parts and special-purpose products using electrodes-tools with higher electrical discharge properties, Vestn. Perm. Nats. Issled. Politekh. Univ., 2017, vol. 19, no. 3, pp. 151–162.
Ablyaz, T.R., Khanov, A.M., and Khurmatullin, O.G., Sovremennye podkhody i tekhnologii elektroerozionnoi obarabotki materialov: uchebnoe posobie (Modern Approaches and Technologies of EDM Processing of the Materials: Manual), Perm: Perm. Nats. Issled. Politekh. Univ., 2012.
Patel Vijay, D., Patel, D.M., Patel, U.J., et al., Review of wire-cut EDM process on titanium alloy, Int. J. Eng. Res. Appl., 2014, vol. 4, no. 12, pp. 112–121.
Rebrova, I.A., Planirovanie eksperimenta: Uchebnoe posobie (Experiment Planning: Manual), Omsk: Sib. Avtom.-Dorozhn. Inst., 2010.
Funding
Financial support was provided by the Russian Ministry of Science and Higher Education (project FSNM-2020-0028).
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by B. Gilbert
About this article
Cite this article
Shlykov, E.S., Ablyaz, T.R., Muratov, K.R. et al. Electrical Discharge Machining of Parts Produced by Additive Technology. Russ. Engin. Res. 41, 455–456 (2021). https://doi.org/10.3103/S1068798X2105021X
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X2105021X